Table of contents
show
Sharper Image 206890 Surround Sound Shower System User Guide
SAFETY INSTRUCTIONS
- Please make sure the plug cover is tight before you place the device around water.
- Keep the device away from extreme weather to prevent electric shock, explosion or bodily injury.
- Do not use the device in or around excessive heat: Direct sunlight, near stove tops or open flames, etc.
- Keep device out of the reach of children. Do not operate at excessive volume levels as this may damage hearing.
- Clean the product with a soft cloth free of harsh or corrosive chemicals. Always unplug from the power source before cleaning.
- Do not puncture or disassemble the exterior surface of the device in any way.
- Do not insert metal objects into the device as this could cause electrical shock.
PACKAGE CONTENTS
- BT Shower Speakers
- USB Charging Cable
- Dedicated Suction Cup
KEY FUNCTION
- Hold the power button for 3 seconds to switch speaker on and off.
- Short press for multi-color LED light:
- Rotate colors
- Select color
- No color/light
FEATURES
- Wireless 5.0
- Waterproof IP grade: IP67
- Hands-free talking
- Strong suction cup
- FM radio
- Multi-color LED light
- Charges via USB
SPECIFICATIONS
- Frequency Range: 100Hz-20KHz
- Operating Distance: 10 meters
- Microphone: Built in
- Power Rating: 5W
- SNR: ≥85+2 dB
- Charging Voltage: DC 5V
- Battery Capacity: 650mAh
- Charge Time: Approx. 4 hours
- Playback Time: Approx. 8 hours
- Housing Material: ABS + Silicone
WIRELESS PAIRING
Charge the speaker for 3 full hours prior to initial use.
- Make sure that the speaker is powered off. Place your mobile phone or media player device next to it. Press and hold the power button for 3 seconds to enter pairing mode. If Bluetooth disconnects, the speaker will shut down automatically after 10 minutes.
- Activate the wireless feature on your media player device and search the list for“SI AUDIO.” Enter “0000” if prompted for a password.
- If pairing fails, refer to your media player device’s user manual. Remove paired devices from the list and start over at step 1.
TWS CONNECTION
Follow these instructions when first using the TWS function:
- Turn on one of the speakers and pair your device to the host speaker.
- Turn on the second speaker in Bluetooth mode.
- In Bluetooth mode, press and hold on the host speaker. Stop pressing after you hear the connection sound.
IN TWS MODE
You can control volume, change previous song/next song, play/pause, power off, etc. from either of the two speakers. Press and hold to cut off the TWS connection between them.
NOTE: TWS only works with Bluetooth
- In FM mode, two speakers can’t be used as TWS. FM radio functions individually.
- When answering an incoming call, the caller’s voice can only be heard through the host speaker.
RECHARGING
The wireless speaker is powered by a built-in rechargeable lithium battery. To charge:
- Release the DC 5V charging port cover.
- Connect the USB charging cable to a standard USB charging port
PRODUCT FEATURE
TROUBLESHOOTING
| Symptoms | Causes | Solutions |
| Speaker Can’t be powered on | Low battery level | Recharge the battery |
| Not able to pair with the speaker | Speaker is already on or not in pairing mode. | Refer to “Wireless pairing section” |
| Volume too low | Battery is not charged up or volumeis not set the max on both the speaker and media player. | 1. Increase the volume by pressing and holding the volume up button. 2. Increase the volume on your media player. |
|
FM Radio Signals | 1. To receive optimal FM radio signals, relocate your speakers to an open environment. Move it away from other electronic devices to reduce the interference. 2. If applicable, use an external antenna to possibly increase the signal strength. | |
