Table of contents
show
BELL HOWELL 2963 Solar Outdoor Lights User Manual
PARTS & FEATURES
- Adjustable Solar Panel
- Adjustment Knob
- Swivel Arm
- Mounting Plate
- 8 LED Lights
- Motion Sensor
- Sensor Mode/OFF Switch
- Ground spike
- Stake
Package includes:
- Bionic Spotlight
- 3 screws
- 3 plastic anchor
- 1 ground spike
- 1 stake
INSTALLATION
PLEASE READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP IT FOR FUTURE USE.
- When picking a place to install your Bionic Spotlight, CHOOSE A LOCATION WITH MAXIMUM SUN EXPOSURE DURING THE DAY.
- Do not use the spotlight to force the stake into the ground. First, insert the stake into the ground and then place a spotlight over the stake.
- Avoid areas under trees or bushes as this will prevent a proper charge of the Bionic Spotlight.
- Do not install a Bionic Spotlight near an existing outdoor light. The built-in sensor will prevent it from turning the solar lights on.
- When using the Bionic Spotlight in the fall and winter, please note that due to fewer daylight hours, the batteries might not charge fully. This may affect the amount of time the Bionic Spotlight will be on.
- During cold winter months, we recommend removing the Bionic Spotlight to prevent damage to the unit due to frost and freezing temperatures.
MOUNTING SPOTLIGHT
- Remove the Mounting Plate from the spotlight by twisting the dial counterclockwise.
- Choose a location with maximum sun exposure. Drill holes matching the pattern on the Mounting Plate and install plastic anchors (included). Attach the Mounting Plate using 3 screws (included).
- Align the arm of the spotlight with the opening on the Mounting Plate. Twist the dial clockwise to tighten and secure it.
FOR IN-GROUND INSTALLATION
Make sure that the Mounting Plate is attached to the swivel arm of the unit.
- Insert Ground Spike into the Stake.
- Make sure the soil is softened. Insert Stake into the ground.
- Insert spotlight over the Stake.
ADJUSTING ANGLES
- To adjust the angle of the Solar Panel, loosen the Adjustment Knob (2). Once desired angle has been selected, tighten the knob.
- Swivel the arm (3) of the spotlight to direct the light where needed.
USAGE
Make sure you read and follow the installation directions prior to use.
- When using it for the first time, turn the Bionic Spotlight ON by sliding the switch located on the back of the solar panel to the Sensor Mode position.
- Leave the unit under direct sunlight for solar charging at least 5-6 hours. UNIT NEEDS TO BE FULLY CHARGED BEFORE INITIAL USE. If there isn’t ample sunlight, it may take longer for the batteries to charge.
- Once it becomes dark, the Bionic Spotlight will turn on automatically when it detects motion. The light will stay on for 30 seconds and then will go off if no motion has been detected.
- The Bionic Spotlight will turn off during the day or if unit runs out of battery.
- Security Camera likeness: Once the unit is in the Sensor Mode (ON) position, the red LED light will blink on the front of the spotlight. The red light will remain blinking until motion is detected and the spotlight turns on.
TROUBLESHOOTING
TECHNICAL INFORMATION
- Product size: L6.3 x W3.58 x H4.72In / 16×9.1x12cm
- Net weight: 0.64lb / 290g
- Sensor distance: 6-9 meters
- Lighting time: 30s
- Color Temperature: 6500K-7500K
- IPX Rating: IPX4
