Table of contents
show
PULSAR 510 Payout 2.0 Vape Cartridge Battery User Manual
Important Safety Warnings
- Do not expose to extreme temperatures or direct sunlight.
- Do not drop the device or accessories.
- Do not drop or submerge in any liquid.
- Do not modify the electronics in any way.
- This device is intended for adults only. Do not sell or provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. This is not a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease.
What’s In The Box
- 510 Payout 2.0 Device
- USB-C Charge Cable
- Collar Adapter
- Wrist Lanyard – 6 in
How To Use
- Connect the Payout 2.0 to the USB-C charge cable and to a power source. Fully charge the device before use, approximately 1.5 hours. Disconnect from the power source before using.
- Click the power button 5 times to turn on. (If you click it once, the Payout 2.0 will remind you to click 5 times to turn it on)
- Screw in your 510-threaded cartridge, until the display indicates that the cartridge is successfully attached. If using a wider cartridge, first screw in the collar adapter, then insert the cartridge.
- Click the power button twice to activate the pre-heat function (1.8V for 15 seconds).
- Use the PLUS or MINUS buttons to set your preferred voltage, between 1.8 and 4.2V.
- Hold down the power button to fire the vape, for up to 15 seconds at a time, and draw from the cartridge mouthpiece. After 15 seconds, the battery will stop firing. Repeat as desired.
- After use, click the power button 5 times to turn off and extend the life of your battery. The Payout 2.0 will turn off automatically after 5 minutes of inactivity.
SPECS
- Dimensions: 61.5 x 20 x 21 mm (2.4 x 0.75 x 0.8 in)
- Battery Capacity: 400mAh
- Resistance: >1 Ohms
- Variable Voltage: 1.8 to 4.2 V in 0.1 V increments
- 15-second pre-heat
- 15-second vape time
- 5-minute auto shut-off
- 1.5-hour charge time
- Short circuit protection
Features
