Table of contents
show
8BitDo Arcade Stick for Xbox User Manual
Instruction manual
- audio switch
- headphones on mic off
- all off mode switch
- Joystick mode
- gamepad mode
- view button
- share button
- menu button
- joystick
- joystick switch
- Left joystick
- D-Pad
- Right joystick
- star button
- Xbox button
- profile LED
- power LED
- microphone mute LED
- status LED
- profile button
- 2.46 receiver
- 3.5mm audio jack
- Press the Xbox button to turn on the Arcade Stick
- Hold the Xbox button for 6 seconds to turn off the Arcade Stick
- Hold the Xbox button for 12 seconds to force the Arcade Stick off
Windows
- required system: Windows 10 (1903) or above
Wireless connection
- connect the 2.4G receiver to the USB port of your Windows device
- rest on dutitor to an en made Stick, wait l the rcade Stick is sucestly ecognized by the device, status LED stays solid
Wired connection
- turn the mode switch to gamepad mode
- connect the Arcade Stick to your Windows device via USB cable, wait till the Arcade Stick is successfully recognized by the device, status LED stays solid
Xbox
- Xbox Series, Xbox One consoles are supported, Xbox 360 console is not supported
- The latest firmware version of your Xbox console is required
Wireless connection
- connect the 2.4G receiver to the USB port of your Xbox device
- turn the mode switch to gamepad mode
- press Xbox button to turn on the Arcade Stick, wait till the Arcade Stick is successfully recognized by the Xbox console, status LED stays solid Wired connection
Wired connection
- turn the mode switch to gamepad mode
- connect the Arcade Stick to your Xbox console via USB cable, wait till the Arcade Stick is successfully recognized by the Xbox console, status LED stays solid
Button Swap
- press and hold any of the two buttons you would like to swap, then press the star button to swap them
- press and hold any of the two buttons which have been swapped and press the star button to cancel it
- the profile LED will blink continuously when the swapped buttons are pressed
- the swapped buttons will not be saved after the Arcade Stick is turned off
- Joystick, view/menu/share and Xbox buttons are not supported
Volume Control
- beeps when adjusted to maximum/middle value/minimun
- press and hold profile + up/down to turn up/down in-game volume
- press and hold profile + left/right to adjust the balance between voice and game volume
Battery
Status LED indicator –
LED indicator –
low battery
red LED blinks
battery charging
green LED blinks
battery full charged
green LED stays solid
- heidinesand win curseria teny with 30 hours of play time 20 hours when connected with
Ultimate Software
- press profile button to activate customised profiles. The profile LED will not light up when using the default setting
- It gives you elite control over every piece of your Arcade Stick: customize button mapping, adjust stick & trigger sensitivity, and vibration control. Please visit support.8bitdo.com for the application
Re-pair the Arcade Stick and Receiver
follow the steps below to re-pair the Arcade Stick and receiver:
- with the Arcade Stick off, press and hold the star and profile buttons, then press Xbox button to turn on the Arcade Stick, the status LED will blink rapidly
- plug the receiver into the USB port of your Windows device or Xbox console, wait for the Arcade Stick to pair with the receiver automatically
- the LEDs on both Arcade Stick and receiver will stay solid when the connection is successful
Support
Please visit support.8bitdo.com for further information & additional support
REFRENCE LINK
