Dreo Pilot Pro Tower Fan User Manual
IMPORTANT SAFETY INSTRUCTIONS
General Safety
- Children shall not play with the appliance. Cleaning and maintenance shall not be performed by children without supervision.
- Use the appliance as described in the user manual only. Any other use not recommended in the user manual may cause fire, electrical shock, or personal injury.
- This appliance can be used by children aged above 8 years and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of this appliance in a safe way and understand the hazards involved.
Operation Safety
- Place the appliance on a flat, dry surface before use.
- Do not immerse in water and any other liquids.
- Do not use the appliance until the base is installed.
- Do not insert your fingers, pencil and any other objects into the grilles while in operation.
- Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.
Electricity Safety
- Make sure that the voltage of your electricity supply is the same as that indicated on the appliance.
- Always unplug before cleaning or leaving the appliance unused for a long period of time. Keep your hands dry when plugging/unplugging.
- Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- WARNING: To reduce the risk of fire or electric shock, do not use This Fan with any solid-state speed control device.
- 24V/1.5A power adapter only. Turn off the appliance before unplugging.
ASSEMBLING YOUR TOWER FAN
Assembly Instructions
When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.
Package Contents
Control Panel
LED Display
Getting the Most out of Your Tower Fan
- It’s not an air conditioner.
- Remove any tall obstacles that might block the airflow from the fan.
- Combine with your AC unit to get cooler air throughout the room.
- Position the tower fan closer to you to get more direct airflow.
- Place a bucket of ice in front of the fan for an extra cooling boost.
USING YOUR TOWER FAN
General Operations
Working Modes
Sleep Mode
• (Mute Auto On)
Fan speed decreases every 30 minutes .Speed decreases by three or two levels at most and will remain constant if at level 3, 2 or 1:
- For level 12: 12 11-+10-+9
- For level 11: 11-+10-+ 9-+8
- For level 10: 10-+9-+8-+7
- For level 9: 9-+8-+7-+6
- For level 8: 8-+7-+ 6
- For level 7: 7-+6-+5
- For level 6: 6-+5-+4
- For level 5: 5-+4-+3
- For level 4: 4-+3
- For level 3: 3
- For level 2: 2
- For level 1: 1
Auto Mode
- Fan speed adapts to the ambient temperature .
Normal Mode
- The fan runs at a constant speed.
Natural Mode
- The fan runs at alternating speeds.
- Touch the Oscillation button (9 and its icon will flash for 5 seconds on the display. During the flashing process, touch (±) or change the oscillation angle.
- The display will show 1/2/3/4, indicating the current oscillation angle is set to 30/60/90/120 degrees.
Note: To adjust/speed, please wait until (9 stops flashing.
Timer
When the fan is ON/OFF, touch the timer button (9 repeatedly to set a timer from 1 to 12 hours. When the timer ends, the fan will stop/start running automatically. To cancel, set the time to 0 hours.
Note: When the auto-off timer is enabled, the display will return to fan speed after 3 seconds.
Mute
Method 1: Short press the mute button x on the remote control to turn on/off button sounds.
Method 2: Long press the mode button @ on the control panel to turn on/off button sounds.
Memory
If the fan is turned OFF or disconnected from power, it will operate under the previous settings (except the timer setting) when it is turned ON again.
Remote Control
Battery replacement
- Press the locking button to pop out the battery holder.
- Replace with the same battery type with the(+) side facing up.
- Push in the holder until securely locked into place.
Note: If the indicator on the remote control doesn’t tum on anymore, please consider replacing the battery.
CLEANING AND MAINTENANCE
TROUBLESHOOTING
My Fan Won’t Turn On
- Make sure that the cord is connected to a powered outlet and that the mains voltage corresponds with the voltage indicated on the fan.
- Check if the power adapter is securely inserted into the power outlet and the tower fan.
My Fan is Shaky and Wobbling
- Place the fan on a flat, level surface.
- Incorrect installation might also cause shakiness. Please refer to the assembly instructions in
The fan is making Vibration and Noise
- Place the fan on a flat, level surface.
- Be sure not to insert anything into the air inlet and outlet.
Default 12-Month Warranty
This appliance is covered by a Dreo warranty for 12 months from the date of its original purchase.
Extend Your Warranty
Extend your warranty by registering your new appliance on our website
The warranty will not apply In cases of:
- Accidents, misuse, or repairs performed by unauthorized personnel.
- Any unit that has been tampered with or used for commercial purposes.
- Normal wear and tear of wearable parts.
- Use of force, damage caused by external influences.
- Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or noncompliance with the instructions.
- Partially or completely dismantled appliances.
- Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by Dreo.
we can only provide after-sales service for products that are sold by Dreo or Dreo-authorized retailers and distributors. If you have purchased the appliance from a different place, please contact your seller for return and warranty issues.
FCC Statement
This device complies with Part 15 of the FCC Rules. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
REFERENCE
https://www.dreo.com/support/product/dreo-pilot-max-tower-fan
