DREO PTC DR-HSH001 Fan Heater User Guide

DREO PTC DR-HSH001 Fan Heater User Guide

IMPORTANT SAFETY INSTRUCTIONS

Dreo PTC DR-HSH001 fan heater user guide SAFETY INFORMATION AND INSTRUCTIONS. KEEP FOR FUTURE REFERENCE. FOR HOUSEHOLD USE ONLY
When using electrical  appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

• Read all instructions before using this heater.
•  This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture,pillows, bedding, papers, clothes,
  and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
•  Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• Always unplug heater when not in use.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
•  Do not use outdoors.
•  This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.Never locate heater where it may fall into a bathtub or other water container.
•  Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• To disconnect heater, turn controls to off, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
•  A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,paint, or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• Always plug heaters directly into a wall outlet/ receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
•  A loose fitting outlet can cause the plug to overheat or cause a fire. Be sure plug fits tight in the outlet.
• If there is a loose fit between the plug and the socket or the plug becomes very hot, the socket may need to be replaced. Check with a qualified electrician to replace the socket.

Package Contents

• 1 x TC Fan Heater
• 1 x Remote Control
• 1 x Thank You Card
• 1 x User Guide

Using your Heater

Product Diagram

Control Panel

Remote Control
Note: All the functions can be achieved through the buttons on the remote control.

Operations and Functions
Place the heater on a firm, level surface free from obstructions, and at least 3ft. (0.9m) away from any wall or combustible material. Plug into an appropriate voltage AC 120V outlet, The unit will enter standby mode with a beep and power indicator on red. Your heater is ready for use now. Read complete for Dreo PTC DR-HSH001 fan heater user guide.
Power ON/OFF

• The Power indicator ( ) lights up when the heater is switched on.
• Press @ on the heater / remote control once to turn the heater on with default settings: Power indicator on red, default temperature “95°F” & high heat level “HI” on LED display.
• Press @ once again to turn the heater off. If the heater is operating, it will take 15 seconds for the heater to shut off, with the countdown time shown on the display.

Mode/ Heat Level Settings

•  When the unit is on, repeatedly press @ on the heater / remote control to cycle through High (HI) ->Low (LO) -> ECO -> High (HI) modes.

ECO Mode

•  When ECO mode is turned on, the heater will adjust the working mode (High or Low) automatically based on the ambient temperature.
• You can also adjust the set temperature by pressing (±) or e .
• When the set temperature is reached, the heater will stop working.
• “ECO” will light up on the display when ECO Mode is selected.

Mute/ Unmute

• Hold @ on the heater for 3 seconds, OR press the @ button on the remote control to turn the buzzer on or off. The” Hl””, LO” and “ECO” will flash once along with a beep sound if Mute/Unmute is enabled.

Temperature Adjustment

• When the unit is on, press (±) or0 on the heater I remote control to adjust the temperature from 41 to 95°F in 1°F increments.
• When the set temperature (TO) is reached, the heater will stop working. When the ambient temperature is lower than the set temperature, the heater will start working again.

Oscillation Button

•  When the unit is on, press @ on the heater/ remote control to start oscillating.
•  To stop oscillating, press @ again.

Auto OFF Timer

• When the unit is on, press @ on the heater/ remote control to cycle through 00 -> 01 -> … -> 12
  -> 00 -> 01 hour timer. When the time is up, the unit will automatically stop running.
• To cancel Timer setting, press and hold @ on the heater for 3 seconds, or adjust the timer setting to 00, or turn the unit off.

Auto LED Display OFF

•  If no operation is done within 1 min. after powered on, the display will turn off automatically (Only the power indicator light and working mode light will be on).
• To turn the display back on, press any button to wake it up.

Other Features

Specification

CLEANING AND MAINTENANC

Troubleshooting

The following troubleshooting guide addresses the most common problems. If problems persist, contact the Customer Support at  support@dreo.com.

WARRANTY AND SERVICE

Warranty and Service
Default 12-Month Warranty
Thanks for choosing DREO heater. This product is covered with DREO product and labor warranty for 12 months from the date of its original purchase.
Extend Your Warranty
Extend your warranty by registering your new product on our website https://dreo.com/warranty.

The warranty will not apply in cases of:

• Accident, misuse, or repairs performed by unauthorized personnel.
• Any unit that has been tampered with or used for commercial purposes.
•  Normal wear and tear of wearable parts.
•  Use of force, damage caused by external influences.
•  Damage caused by non-observance of the User Guide, e.g. connection to an unsuitable mains supply
  non-compliance with the instructions.
• Partially or completely dismantled appliances.
•  Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by DREO.

We can only provide after-sales service for products that are sold by DREO or DREO authorized retailers and distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty issues.

Customer Support
We’re Here to Help!
If you encounter any issues or have any questions regarding your new product, please contact our helpful Customer Support Team. Your satisfaction is our goal!
Email: support@dreo.com
“Please have your order confirmation number ready before contacting Customer Support.

Reference:

https://www.dreo.com/support/product/dreo-solaris-max-space-heater

https://www.dreo.com/

Buy Related Product on Amazon

Buy on Amazon