Insignia Armband Radio User Guide
Welcome
Congratulations on your purchase of a high-quality Insignia product. Your NS-R5111A Armband Radio represents the state of the art in design and reliable, trouble-free performance.
Features
- AM/FM digital radio
- Stereo or Mono listening modes
- Easy preset digital tuning and up to 10 FM and 10 AM memory presets
- Wearable oval design for armband and belt-clip use
- Stereo headphones
Package contents:
- Armband radio
- Armband
- Headphones
- User Guide
- AAA batteries (2)
Using your armband radio
Display
Installing the batteries
Notes
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Dispose of batteries according to local environmental laws.
When the batteries are low, the LCD will start flashing and eventually shut off.
- Press the ON/OFF button to turn off the radio, then replace the batteries.
Note
Time and memory will be saved if you change the batteries within two minutes.
- Open the battery compartment door located on the back of your radio.
- Insert two AAA batteries, making sure that the + and – on the batteries match the + and – inside the battery compartment.
- Replace the battery compartment door.
Operating your radio
To operate your armband radio:
- Press the ON/OFF button to turn on the radio.
- Press the BAND button to select AM or FM.
- Insert the headphone plug into the Phone Jack.
Note
Your headphones’ soft wire works as the antenna for FM reception. You may need to extend the wire to obtain the best reception.
To listen to your radio:
- Press and release the TUNE UP or TUNE DN button to go to the next radio station.
- Press and hold the TUNE UP or TUNE DN button to scan for the next radio station with clear reception.
- Press the volume control button + or – to adjust the volume.
- Press and release the STEREO/TIME SET button to select Stereo or Mono mode.
Note
Stereo mode is only available when listening to FM radio stations.
To manually store stations:
- Press the BAND button to select AM or FM.
- Press the TUNE UP or TUNE DN button to select the radio station you want.
- Press the MEMORY button. The PRESET Indicator on the LCD flashes.
- Press the PRESET button to select the preset channel you want.
- Press the MEMORY button again to store the station as a preset.
- Repeat Steps 1 to 5 to store additional stations.
Note
You can store up to 10 AM and 10 FM radio stations into preset numbers (erasing any preset stations).
To recall preset stations within the selected band:
- Press the PRESET button to go to a stored station.
Using Hold
- Set the HOLD switch to ON and all buttons will be disabled. The Hold indicator appears on the LCD.
- Set the HOLD switch to OFF to enable all buttons.
Setting the time
- Turn off the radio.
- Press and hold the STEREO/TIME SET button.
- Press the TUNE UP button (hour) to set the hour, then press the TUNE DN button (minute) to set the minute.
- Press the STEREO/TIME SET button to exit Time Set mode.
Note
You cannot set the time during power on mode.
Using the belt clip
- To release the belt clip, pull the top end of the belt clip outward, then hold it and slide it down gently.
Specifications
Troubleshooting
Safe sound levels*
To establish a safe sound level:
- Start with the volume control at a low setting.
- Slowly increase the sound until you can hear it comfortably and clearly, without distortion.
- Avoid prolonged exposure to excessive noise.
ONE-YEAR LIMITED WARRANTY
Definitions:
The Distributor* of Insignia branded products warrants to you, the original purchaser of this new Insignia branded product (“Product”), that the Product shall be free of defects in the original manufacturer of the material or workmanship for a period of one (1) year from the date of your purchase of the Product (“Warranty Period”). For this warranty to apply, your Product must be purchased in the United States or Canada from a Best Buy branded retail store or online at www.bestbuy.com or www.bestbuy.ca, and is packaged with this warranty statement.
DOWNLOAD PDF LINK
