Poly-Ultrasonic-Humidifier-User-Manual-FeatureImage

Poly Ultrasonic Humidifier User Manual

Poly logo

Poly Ultrasonic Humidifier User Manual

Poly-Ultrasonic-Humidifier-User-Manual-Image-1

Important Safety Instructions

Read all instructions Before Using Humidifier Especially These basic Safety Precautions
  1. Always place humidifier on a firm, flat, level surface. Keep cord away from heated surfaces and out of the way, where it can not be stepped on or tripped over.
  2.  Before using the humidifier, extend the cord and inspect for any signs of damage. Do not use product if cord has been damaged.
  3. To avoid the risk of fire, shock or personal injury, do not use an extension cord.
  4. Humidifier should always be unplugged and emptied when not in operation or while being cleaned. Shut off and unplug humidifier before moving. Do not move or tilt humidifier while it is operating. Plug and unplug unit with dry hands.
  5.  Do not operate without water. Turn off unit when tank is empty.

Using Your Ultrasonic Humidifier

Read all instructions before using this appliance. Unpack and remove all packing material from the Water Tank, Mist Nozzle and Base. Completely unravel power cord and place unit on a flat, stable surface. Remove the protective wrapper from the demineralization cartridge and place into the unit as shown.

Filling the Water Tank:

Always UNPLUG the humidifier before filling.

  1. Remove the Water Tank from the Base and turn it upside down. Turn the Tank Cap counterclockwise to open. Rinse and wipe clean.
  2. Fill the Water Tank with clean, cool, tap water and replace the Tank Cap by firmly turning clockwise. Turn the Tank upright and check Tank Cap for leaks. If any water drips from Tank Cap, remove it and re-tighten. Use of very cold water may temporarily reduce the mist output. Never fill the humidifier with hot or warm water as this could cause damage and void your warranty.To avoid white dust we recommend using a Kaz Demineralization Cartridge (Model DC-51) and replacing it after 30-40 fillings. If you live in an extremely hard water area you may also wish to use distilled water to further reduce white dust. Refer to About White Dust.
  3. Inspect the Base and Nebulizer for cleanliness. Refer to Care and Cleaning section.

Operating Instructions

  1.  Do not operate the humidifier without water in the Water Tank.
  2.  After filling the humidifier, be sure the Power Switch is in the OFF position, then plug the power cord into a 120 volt AC wall outlet.
  3.  Turn the Power Switch to the On position and then set.
  4. Mist will not appear immediately; allow a few minutes for the water to fill the Reservoir. If  you are using a new Demineralization Cartridge, it may take up to fifteen minutes for the filtering material to become saturated and for mist to appear.
  5.  Direct Mist Nozzle away from walls and furniture. If condensation forms on walls or windows, or if indoor relative humidity exceeds 50%, reduce Mist Intensity Control setting, open door to room where humidifier is operating, or turn unit off.

Weekly Maintenance:

  1.  Thoroughly clean humidifier every week using a solution of bleach and water one tea spoon of bleach in one gallon of water. Fill Tank partially with this solution, let stand twenty (20) minutes, shaking vigorously every few minutes, drain and rinse with clean water until the bleach smell is gone.
  2.  Wipe the Reservoir with a soft cloth dampened in the solution. Rinse area thoroughly before proceeding.
  3.  If mineral deposits are evident around the Nebulizer and Water Sensor, clean their surfaces with a soft, clean cloth and a small amount of undiluted white vinegar. If necessary for removal of mineral deposits, mix a solution of 50% white vinegar and 50%water and fill the Base with enough solution to cover the Nebulizer.

End of Season Maintenance

  1.  Follow above weekly cleaning procedure at the end of the humidification season, or when the humidifier will not be used for several days, being sure to dry all parts, including the inside of the Water Tank. Do not store with water inside.
  2.  Leave Tank Cap partially loosened during storage to prevent Tank Cap and gasket from sticking together. This will prolong the life of the gasket.
  3.  Clean the Tank and Base after long periods of storage.

Troubleshooting Guide

Poly-Ultrasonic-Humidifier-User-Manual-Image-1

Note: Failure to keep this unit clean from mineral deposits normally contained in any water supply will affect the efficiency of operation of this unit. Customer failure to follow these instructions may void the warranty.

DOWNLOAD PDF

Poly Ultrasonic Humidifier User Manual

REFERENCE LINK

https://www.poly.com/us/en

Leave a Reply