Cocoon IT315007 Voyager Quadcopter User Manual
Getting Started Guide
UNPACK
Unpack the Cocoon Voyager Quadcopter from the packaging and check you have all the components:
- 1 x Voyager Quadcopter
- 1 x Remote Control
- 4 x Replacement Propellor Blades
- 4 x Blade Guards
- 1 x Screwdriver
- 1 x USB Charging Cable
- 4 x ActivEnergy AA Batteries
- 1 x Instruction Manual
- 1 x Getting Started Guide
- 1 x Warranty Card
CHARGE BATTERY
- Switch the Voyager Quadcopter off and open the battery cover.
- Pull the battery wire out of the power port and remove the battery.
- Plug the battery wire into the smaller end of the USB charging cable.
- Connect the USB cable to an active USB port.
Note: A full charge will take roughly 75 minutes.
INSERT BATTERIES
- Remove the screw from the back of the remote control and remove the battery cover.
- Insert 4 x AA batteries (taking note of polarity) and replace the battery cover.
- Reverse the steps in Section 2 to reconnect the battery to the Voyager Quadcopter.
TURN ON THE VOYAGER QUADCOPTER AND PAIR REMOTE CONTROL
- Set the switch on the Voyager Quadcopter to “On” and place it on a flat, horizontal surface.
- On the remote control, set the power switch on the front to the “On” position.
- Push the left control stick to the highest position until you hear the remote control beep, then pull down to the lowest position until you hear another beep.
Note: When successfully paired, the lights on the Voyager Quadcopter will stop flashing and change to solid colors.
FLY Note:
Incorrect operation of this Voyager Quadcopter may result in severe injury, loss of property, or fines. Winplus Australasia does not take any responsibility if local rules and regulations are not followed. Note: The best way to know which direction the Voyager quadcopter is facing is by the colored LEDs on its wings. The red lights will face forwards, while the green lights face backward. Always keep the Voyager Quadcopter in direct line of sight.
Hover up and down Push the left control stick up or down. The Voyager Quadcopter will fly upward or downward.
Forward and backward Push the right control stick up or down. The Voyager Quadcopter will fly forward or backward.
Turn left and right Push the left control stick left or right. The Voyager Quadcopter will turn left or right.
Sideward fly Push the right control stick left or right. The Voyager Quadcopter will fly left or right.
FURTHER INSTRUCTIONS
For further flying instructions, as well as advanced techniques, please refer to the instruction manual provided.
