Panasonic Learning AccuPulse 4.0 to the Controller User Manual

Table of contents show

Panasonic Learning AccuPulse 4.0 to the Controller User Manual prduct img

Initial learning is learning new tools not yet learned by the controller

Do the “Adjust Torque Offset” first with the Panasonic Tool Manager Software
After you finish “Adjust Torque Offset” Put the tool in “Wireless mode”. Then “write to the tool”
1. A. Unplug the tool. It will display E9 because it’s not learned yet by the controller
Choose the Tool slot you want to learn the tool to
Select Learn and follow the onscreen instructions
1. This will learn the current parameter in the tool to the controller.

Editing or Adding Parameters to the Controller with the tool
If you want to replace or add additional parameters 17-100 to existing learned tools

Go to the tools page, select edit, then select “configure”
- This will disable the tool
- If you do not disable the tool and reconnect after editing, the current Controller parameter will replace what is in the tool
Plug the tool back into Panasonic Tool Manager Software
Perform one of the following
- A. “Adjust Torque Offset” and save the parameter
- B. Select a saved parameter and write it to the tool

After you save parameters, you will see under the “Parameter Tab” a list of parameters saved

Select a saved parameter and “Write” it to the tool
- Make sure the “Wireless mode” is selected. If not, select it and write to the tool again
Unplug the tool and select the parameter on the controller screen that you want that parameter saved to
1. 17 – 100 for additional parameters
2. 1 – 16 if you want to write over the existing tool parameter
3. Only the tool that is being configured
Select “Read” and then “Done”
The screen will go back to the tool page
Select Save and exit

Parameters 17 – 100 will need to be edited and assigned the tool you want associated with.

Select a parameter from the list. Make sure the parameter is set to “Wireless mode”
Select the export tab. This will save the parameter to the file location you choose as a .csv file and name it
Copy the .csv file to a thumb drive. It can only have that file and nothing else on the drive. Only one file at a time
Put the thumb drive in the USB on the side of the controller
Choose “upload USB file to device” on the popup screen
Select “Yes” on the Parameter
Assign that parameter
Assign the tool
Select Upload

Panasonic Life Solutions Company of America Assembly Tools Division 2 Riverfront Plaza 5th Floor Newark, NJ 07102