Atrix HCTV5 Series 5 Gallon High Capacity Vacuum System User Guide
IMPORTANT SAFETY INSTRUCTIONS
- Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
- Do not use outdoors or on wet surfaces.
- Do not allow to be used as a toy. Close attention is necessary when used by or near children.
- Use only as described in this manual. Use only manufacturer’s recommended attachments.
- Do not use with damage cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped in water, return it to a service center.
- Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle plug or appliance with wet hands.
- Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
- Keep hair, loose clothing, fingers, and all parts of body away from opening and moving parts
GENERAL INFORMATION
ASSEMBLY OF THE HIGH CAPACITY VACUUM
- Remove all parts from the shipping container.
- Filter is shipped already attached to motor bulkhead.
- Insert either end of the hose into the vacuum intake.
- Insert detachable power cord into the vacuum head and insert other end into the grounded wall outlet.
- The High Capacity Vacuum is now ready for use.
- Assemble roller base and use for extra mobility.
FILTER REPLACEMENT
- Remove power cord from power source.
- Unfasten retaining clips (3) from vacuum head. Lift vacuum head off of the filter.
- Place filter lid securely on the filter. The filter is now ready for disposal.
- Apply new filter below vacuum head and fasten (3) retaining clips.
- Plug the power cord in the power source.
NOTE: These vacuums have a factory installed reset table Thermal Cutout (TCO) for added operator and motor safety. If the unit gets too hot, the vacuum will shut down for approx. 20 minutes. Turn the on/off switch to the off position, and turn back on in approximately 20 minutes.
WARRANTY
For warranty service information, please contact your local distributor. Warranty period for the High Capacity Series is 18 months. When using the Atrix HEPA filter for removing lead or other hazardous waste, the vacuum This warranty is in lieu and exclusive of any warranty of merchant ability, and/or quality, and any application for use for a particular purpose.damage to the vacuum, and will void the warranty. Atrix shall not be liable for special or coincidental damages such as loss of other property or equipment, loss of revenue, personal injury, death.
Standard Replacement Parts
Vacuum Head (Power Unit) 421-000-100 (120 Volt)
Filter Replacement, toner, developer, dust and dirt-5 Gallon 421-000-002
Filter Replacement, HEPA-5 Gallon 421-000-005
Detachable Power Cord 10’ office machine end, 110V 31651
ESD Safe Round Dusting Brush 31653
8’2” European Power Cord, 230V 66021A
8’2” U.K. Power Cord, 230V 66097A
Vacuum Roller Base 421-000-105
Toner proof Stretch hose, 10’ ESD Safe 31671
DOWNLOAD PDF
Atrix HCTV5 Series 5 Gallon High Capacity Vacuum System User Guide