IGLOO IGLICEB26RD Automatic Ice Maker Instructions Guide
IMPORTANT SAFEGUARDS
A person who has not read and understood all operating and safety instructions is not qualified to operate this appliance. All users of this appliance must read and understand this Instruction Manual before operating or cleaning this appliance. When using electrical appliances, basic safety precautions should always be followed, including:
- Read all instructions before operating this appliance.
- DO NOT TOUCH the hot surfaces. Use handles or knobs.
- This appliance is NOT A TOY.
Unsupervised young children and cognitively challenged individuals should never operate this appliance. - Close supervision is necessary when any appliance is used by or near children.
- To protect against electrical shock do not immerse the cord, plug, or any part of this unit in water or other liquids.
- Unplug from the outlet when not in use, before removing parts, and before cleaning. Allow to cool before putting on or taking off any parts, and before cleaning.
- DO NOT operate any appliance with a damaged cord or plug, or after the appliance malfunctions, or if the appliance has been damaged in any manner. Return the appliance to the nearest repair shop for examination, repair, or adjustment.
- The manufacturer does not recommend the use of accessory attachments other than what is provided by the manufacturer. The use of attachments may cause injuries.
- DO NOT use the appliance for other than its intended use.
- DO NOT use outdoors. FOR HOUSEHOLD USE ONLY.
- DO NOT place on or near a hot gas or electric burner, or in a heated oven.
- DO NOT let the cord hang over the edge of the table or counter, or touch hot surfaces.
ADDITIONAL IMPORTANT SAFEGUARDS
Operating Safety Precautions
- DO NOT touch the Evaporator while the unit is in use or during the ice-making process. This could cause severe burns.
- DO NOT clean the unit with flammable liquids. The fumes can create a fire hazard or explosion.
- Check the Ice Hopper for the presence of foreign objects prior to use.
- DO NOT turn the unit upside down while in use, or when filled with ice.
- CAUTION: Flammable refrigerant used! When handling, moving, and using the refrigerator, make sure to avoid either damaging the refrigerant tubing or increasing the risk of a leak. Component parts shall be replaced with like components and that servicing shall be done by factory-authorized personnel to minimize. the risk of possible ignition due to incorrect parts or improper service.
- A short power supply cord is provided to reduce the risk resulting from becoming entangled or tripping over a long cord.
- If a long detachable power-supply cord or extension cord is used:
- Extension cords can be used if care is exercised in their use.
- The marked electrical rating of the cord or extension cord should be at least as great as the electrical rating of the appliance.
- When using a longer cord or extension cord, make sure that the cord does not drape over a countertop or tabletop where it can be pulled on or tripped over unintentionally.
- The manufacturer does not recommend using this machine in countries that do not support 120V AC even if a voltage adapter, transformer, or converter is in use.
INTRODUCTION
Congratulations! You are now the proud owner of the AUTOMATIC ICE MAKER from Igloo®! This stylish and portable ice maker allows you to make ice accessible virtually anywhere. With its intuitive, easy-to-use design, you’ll be making ice cubes soon after you plug in your new appliance. Perfect for the kitchen, RVs, clubhouses, home bars, and more!
Features:
- Makes up to 26 lbs. of ice per day
- Produces 9 ice cubes every 7-15 minutes
- Water tank capacity: 3 quarts
- Ice basket capacity: 2 pounds
- Multiple ice cube sizes: small and large
- Control panel with LED indicator lights
- Compact and elegant design
- Transparent lid for easy viewing
- Removable ice basket
- Includes ice scoop
- Refrigerant: R600A
PARTS & ASSEMBLY
Before first use, be sure to remove all interior and exterior packaging, and follow the steps under CLEANING & MAINTENANCE to properly clean your unit.
- ADD WATER = illuminates when time to add water to the Water Reservoir
- ICE FULL = illuminates when Ice Basket is full
- S = Small ice cube indicator
- L = Large ice cube indicator
- SELECT = press to select the size of ice cubes
- POWER = Press the button to turn the unit ON/OFF
HOW TO OPERATE
BEFORE FIRST USE
- Follow the steps under CLEANING & MAINTENANCE before using this unit.
- Place the unit on a flat, level surface in a location that is protected from direct sunlight and other sources of heat (i.e. stove, furnace, radiator). Ensure there is at least four inches of empty space on all sides of the unit.
- Allow one hour for the refrigerant fluid to settle before plugging the cord into an electrical outlet for the first time.
USING YOUR ICE CUBE MAKER
- Open the Clear Lid to remove the Ice Basket and pour water into the Water Reservoir. Keep the water level below the MAX level mark. If water levels exceed the MAX level mark, drain any excess water by removing the Water Drain Plug.
- Press the POWER button on the LED Control Panel to begin the ice-making cycle.
- Select the desired size of the ice cubes by pressing the SELECT button. If the room temperature is lower than 60°F (16°C), it is recommended to select small-sized ice cubes in order to keep ice from sticking together.
- Each ice-making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selected and the ambient temperature of the room. In extremely hot temperatures, ice-making time may vary considerably.
- While the ice maker is on, check the water level periodically. If the water pump is unable to pump water, the unit will stop automatically and the Add Water light will illuminate.
- If the water level is low, press the POWER button to turn the unit OFF, fill the water up to the MAX level mark, and press the POWER button again to turn the unit again.
- The unit automatically stops working when the Ice Basket is full and the ICE FULL light will illuminate.
IMPORTANT NOTE:
In the event that the power is disconnected during the ice-making cycle or that the LED lights on the Control Panel are blinking, press the POWER button to stop the ice-making cycle. Unplug the unit from the electrical outlet. Allow the unit to sit for a few minutes to let it warm up and allow ice to fall from the evaporator fingers. Empty the Water Tray and wait three minutes before restarting the unit.
HELPFUL TIPS
ADD WATER INDICATOR
If the Add Water Indicator comes on, try the following:
- Turn off the unit, add water, and press the POWER button again to restart the unit.
- There may be too much ice. Turn off the Ice Maker, and remove some ice from the Ice Basket.
ICE CUBES STICK TOGETHER
- The ice cycle may be too long. Stop the Ice Maker, then restart it when the ice cubes melt. Select the smaller-sized ice cubes using the SELECT button.
- The water temperature in the Water reservoir may be too low. Change the water in the Water reservoir. The room temperature should be set between 45˚ F – 90˚ F.
THE ICE MAKER NOT WORKING
If the ice-making cycle seems to be running properly, but no ice is being made, try the following:
- The ambient temperature or water temperature in the Water reservoir may be too high. The unit must be in an environment below 90˚ F. Try pouring colder water (between 45˚ F – 90˚ F) into the Water reservoir.
- If changing the water or allowing the unit to cool does not work, there may be a leakage of the refrigerant fluid or a pipe in the cooling system may be blocked. Please take your ice maker to a qualified technician for repair.
LED LIGHTS
- If the LED lights on the Control Panel are blinking, there may be a disruption in the power source. Press the POWER button to stop the ice-making cycle. Let the ice maker sit for several minutes to let it warm up and allow ice to fall from the evaporator fingers. Empty the Water Tray and wait three minutes before restarting the unit.
CLEANING & MAINTENANCE
Your AUTOMATIC ICE MAKER should be cleaned before storing. Following these steps will help to maintain the unit and add to longevity.
- Unplug the unit from the electrical outlet.
- Remove the Ice Basket, then clean the Ice Basket and Ice Scoop using warm, soapy water, and a soft cloth. Wipe dry with a non-abrasive, dry towel.
- Clean the interior and exterior of the unit using warm, soapy water, and a non-abrasive towel.
- Drain the interior water by unplugging the Water Drain Plug on the bottom of the unit.
- Dry the interior and exterior with a soft, non-abrasive cloth. 6. If the unit has not been in use for a long time, always open the Water Drain Plug and completely drain the water from the Water Reservoir.
RETURNS & WARRANTY
SHOULD YOUR UNIT NOT WORK OR IF DAMAGED WHEN YOU FIRST TAKE IT OUT OF THE BOX, PLEASE RETURN IT TO THE PLACE OF PURCHASE IMMEDIATELY
AUTOMATIC ICE MAKER / IGLICEB26WH
Should you have any questions, please contact us via email or at the customer service number listed below between the hours of 8:00 AM and 5:00 PM, Monday through Friday, Central Standard Time.
Distributed by:
- Nostalgia Products LLC
- 1471 Partnership Dr.
- Green Bay, WI 54304-5685
- Customer Service
- Phone: (833) 258-4210
- Web: www.nostalgiaproducts.com
Customer Service Inquiry
To submit a Customer Service inquiry, go to www.nostalgiaproducts.com fill out the Customer Service Inquiry form, and click the Submit button. A representative will contact you as soon as possible.
Product Warranty Terms
Nostalgia Products LLC (the “Company”) hereby warrants that for a period of one (1) year from the date of original purchase, this product will be free of defects in material and workmanship under normal home use, provided that the product is operated and maintained in accordance with the operating instructions. As the sole and exclusive remedy under this warranty, the Company will at its discretion either repair or replace the product found to be defective or issue a refund on the product during the warranty period.
This warranty does not cover normal wear or damage caused by shipping, mishandling, misuse, accident, alteration, improper replacement parts, or other than ordinary household use. You may be required to return the product (with shipping prepaid by you) for inspection and evaluation. Return shipping costs are not refundable. The Company is not responsible for returns damaged or lost in transit.
Unless otherwise specifically permitted by the operating instructions, this warranty applies to indoor household use only. In order to obtain service under this warranty, please contact the Company at the telephone number listed above or by filling out the Customer Service Inquiry Form located at www.nostalgiaproducts.com. Warranty valid only in USA and Canada.
This warranty does not apply to re-manufactured merchandise.
Please read the operating instructions carefully. Failure to comply with the operating instructions will void this warranty.
For more information, visit us online at www.nostalgiaproducts.com.
Like us on Facebook at www.facebook.com/NostalgiaElectrics.
Follow our boards on Pinterest at www.pinterest.com/nostalgiaelctrx.
Tweet along with us on Twitter at www.twitter.com/NostalgiaElctrx.
REFERENCE LINK
