Topens TC148 Waterproof Wired Wall Push Button User Manual
Installation of the Waterproof Push Button
Step 1: Separate the back cover from the push button and drill four holes in the wall corresponding to the 4 installing holes on the back cover of the push button.
Step 2: Insert plastic anchors into the 4 holes drilled in the wall and then install the back cover to the wall with the screws. (The plastic anchors and the installing screws are not included in the kit).
Step 3: Wire the push button to your opener and then route the wire through the bottom of the push button. Finally fix the front cover of the push button to the back cover with the screws included in the kit.
You can connect the COM and L1 terminals of the push button to the terminals for push button of the gate opener. No matter the polarity.
NOTE: Please read this manual carefully before installation.
Feedback & Review
Your comments and suggestions are important to us as they help us provide the best possible service. Should you have any need to contact us, the info below will help you get in touch:
Contact Us: E-mail: support@topens.com
REFRENCE LINK
