Secrui M520 Wireless Doorbell User Manual

Secrui M520 Wireless Doorbell User Manual

Content

1. Doorbell
2. Push Button
3. Adhesive Sticker
4. Screws & Anchors
5. User Manual

Content will vary according to your kit
The push button supplied with this kit is pre-programmed to operate with the doorbell. If it is not, see “Connect a Push Button” on pages

Safety

1. Open the Transmitter with screw driver and separate the front cover from the back cover. Penetrate the two standby holes at the back cover with two screws. Then fix the screws on the wall at suitable height.
2. Or you can stick the Transmitter with the double-sided adhesive tape.

If you are not mounting the push button to the wall, place it where you want it.

What You Should Know Before Installation

1. Test the operating range you desire. Choose an electric outlet at the height of 3.3 feet at least and plug in the receiver and take the button outside the door to test if it can work well within the range you have chosen.
2. Set a desired music (different or same one) for transmitters before installation. For music setting, see Operating Instructions.Doorbells have been paired and set to a default chime (Ding Dong) before leaving factory.
3. Please do not install transmitter on metal doors since it is hard for the signal to transmit.
4. Please take out the battery insulating strip before using.
5. Ensure all surfaces are clean by wiping the installation area with a clean cloth. Please note that the sticker will have poor adhesion if you attach it to a dirty or uneven surface. Sunlight or rain will also affect the adhesion over a longer period of time.

Product Structure Diagram

AC Powered Receiver

1. CD Music Control
2. Volume Control
3. Plug
4. LED light
5. Speaker

Waterproof Transmitter

Set Up and Operation

Press the push button to test whether it is paired with the doorbell. The doorbell will light up and ring. If it does not, see “Connect a Push Button” on page 5.

Adjust the Volume
When the power is cut off, and power is restored again, the volume will be automatically adjusted to maximum

Installation

Choose a location that is not near a heat source or on something that moves (like a door). For non-mounting locations, choose a place where the doorbell will be easy to see and hear.

For Receiver:
Plug-in receiver: Just plug receiver into standard outlet in room.

For Push button:
Before installation, please test if the operating range you choose is working and set music if needed. Before you drill any hole in the wall, please make sure there are not cables or pipes. To install you will require a drill screwdriver.

Battery Replacement of Push Button

Open the battery cover and install the CR2J  battery.

SPECIFICATION

TROUBLESHOOTING

1 Year Limited Warranty

This product is warranted to the original purchaser only for a period of 1 year from the date of purchase for products damaged due to defect in workmanship and materials. Proof of purchase is required to obtain warranty service. Warranty is for replacement only. No service parts are available for these products. No other warranties are expressed or implied.Batteries are not covered under this warranty. or warranty service, please contact  Customer Service by email: contact@secrui.com

REFERENCE LINK