LASKO CLIP STIK™ ULTRA SLIM DESK FAN
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following:
SAVE THESE INSTRUCTIONS
Read all instructions before using this Fan.
- Make certain the power source conforms to the electrical requirements of the Fan.
- Make certain that the room is equipped with a working smoke detector.
- Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons.
- To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it.
- Unplug the power cord before installing, servicing, or moving the Fan.
Features
- Swivel-action base directs air flow where needed
- 2 quiet speeds
- The Blue Plug™ Patented safety fuse technology
- Simple no-tools assembly
- E.T.L. listed
Specifications
- Size/Height: 3.5″L x 3″W x 10.5″H
- Weight: 2.5 lbs
- Remote: No
- Controls: Manual controls
OVERVIEW
The Clip Stik™ Ultra Slim Desk Fan can be used as a Clip Stik™ Fan or a Desk Fan.
- Desk Fan: To use as a Desk Fan no assembly is required. See Operation Section.
- Clip Stik™ Fan: To properly assemble the Fan with the Clip Assembly, follow the instructions below (Figures 1 and 2) and proceed to the Operation Section.
ASSEMBLY
- Carefully remove the Fan and Clip Assembly from the plastic bag and the carton.
- Slide the Flat Edge of the Clip Assembly end into the Slot on the Bottom Of the Fan.
- Turn the control knob clockwise to the desired speed setting:
0 – Off
2 – High Speed
1 – Low Speed - After turning the Fan Off, unplug the unit from the electrical outlet.
OPERATION
- Place the Fan on a firm and level surface when using this product as a Desk Fan. See instructions below for attaching the Clip Stik™ to a surface.
- CAUTION: Plastic or rubber tabs, like the feet on this unit or the inside of the clip, may stick to furniture surfaces and/or hardwood floors. The unit may leave a residue that could darken, stain or leave permanent blemishes on the finish of certain furniture surfaces, including wood surfaces, and/or hardwood floors.
- Plug the cord set into a 120-volt outlet.
Be sure that the plug fits tightly into the outlet.
When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater.
Attaching Clip Stik™:
Attach the Clip Stik™ to a flat structure that is between 1/4″ and 1 3/4″ thick or a pole 1/2″ to 1 3/4″ in diameter. Attaching the Clip Stik™ to structures with greater or lesser widths may lead to instability.
Pivot and Swivel Movement of Clip Stik™:
(Figures 3 and 4)
- To pivot the Clip Stik™, hold the Clip Assembly and rotate the Fan to the desired position. (Figure 3)
- To swivel the Clip Stik™, hold the Pivot Hinge on the Clip Assembly. Turn the Fan and/or the Clip Assembly from side to side until the desired position is reached. (Figure 4)
TROUBLESHOOTING TIPS
If your Fan fails to operate, see below for a probable cause and solution:
Be sure the power cord is plugged into a working electrical outlet.
If you have a problem that can not be resolved by the steps listed above, contact Technical Assistance at 1-800-233-0268, Monday through Friday, between the hours of 8:00 a.m. and 5:00 p.m. EST.
MAINTENANCE
To reduce the risk of electrical shock and fire please observe the following instructions:
- Always unplug the cord before moving, servicing, or cleaning.
- NEVER place the Fan in or near water.
- Clean the Fan only with a vacuum equipped with a brush attachment; the vacuum will remove the lint and dirt from inside the Fan.
- NEVER attempt to take apart the Fan.
- Clean the body of the Fan with a soft cloth only.
- NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or other harsh cleaners.
SERVICING:
All other servicing, with the exception of general user maintenance, should be performed by an authorized service representative.
Call 1-800-233-0268, Monday through Friday, between the hours of 8:00 a.m. and 5:00 p.m. EST for the location of your nearest service center.
STORAGE: Store the Fan with these instructions, in the original carton in a cool, dry place.
LIMITED WARRANTY
LASKO PRODUCTS, INC. LIMITED WARRANTY (NOT VALID IN MEXICO)
WHAT THIS WARRANTY COVERS:
This product is warranted against defects in workmanship and/or materials.
HOW LONG THIS WARRANTY LAST:
This warranty extends only to the original purchaser of the product and lasts for one (1) year from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs.
WHAT LASKO WILL DO
During the warranty period, Lasko will, at its sole option, repair or replace any part or parts that prove to be defective or replace the whole product with the same or comparable model.
WHAT THIS WARRANTY DOES NOT COVER:
This warranty does not cover shipping costs for the return of products to Lasko for repair or replacement. Lasko will pay return shipping charges from Lasko following warranty repairs or replacement
ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY), LAST ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE
- (I) INCIDENTAL OR CONSEQUENTIAL DAMAGES FROM ANY CAUSE WHATSOEVER, OR
- (II) REPLACMENT OR REPAIR OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING TO THE CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD.
CUSTOMER SERVICE
- Toll-Free (800) 233-0268.
- Email: producthelp@laskoproducts.com
Our Customer Service team is available to assist you with product questions, service center locations, and replacement parts. Please have your model number available, as well as the type and style (located on the underside of your product). Please do not return product to place of purchase.
Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380 (Please do not send product to this location)
www.laskoproducts.com
PARTS FOR DISCONTINUED, OBSOLETE AND CERTAIN OTHER PRODUCTS MAY NOT BE AVAILABLE. DUE TO SAFETY REASONS, MANY ELECTRONIC COMPONENTS AND MOST HEATER COMPONENTS ARE NOT AVAILABLE TO CONSUMERS FOR INSTALLATION OR REPLACEMENT.
