Table of contents
show
SUNBEAM 1501 Rechargeable Cordless Heat Wrap User Manual
IMPORTANT SAFETY INSTRUCTIONS
- DO NOT USE ON AN INFANT OR ON AN ANIMAL.
- DO NOT USE ON AREAS OF INSENSITIVE SKIN.
- CHECK SKIN UNDER PRODUCT FREQUENTLY.
- DO NOT USE IN AN OXYGEN ATMOSPHERE.
- DO NOT USE PINS OR OTHER METALLIC MEANS TO FASTEN THIS PRODUCT IN PLACE.
- DO NOT SIT ON OR AGAINST OR CRUSH PRODUCT– AVOID SHARP FOLDS.
- DO NOT TAMPER WITH THIS PRODUCT IN ANY WAY.
- THERE ARE NO USER-SERVICEABLE PARTS. IF FOR ANY REASON THIS PRODUCT DOES NOT FUNCTION SATISFACTORILY, SEE WARRANTY FOR CONSUMER SERVICE INFORMATION
BATTERY CHARGING:
Install batteries into charger. Positive (+) at top. Plug into an outlet-100 volts to 244 volts , 50/60 Hz. Lights will illuminate red. Once fully charged, lights will turn green. Once charge is complete, place batteries in the controller.
BATTERY INSTALLATION:
- Remove clip from the back of the controller (Fig. 1)
- Slide off battery cover. (Fig. 2)
- Place batteries in controller
- Reattach battery cover to controller.
- Reattach clip to back on the controller
USAGE INSTRUCTIONS:
After Battery Installation:
- Place controller in wrap pouch.
- Plug in connector from wrap.
- Press and hold On/Off button to turn on. Apply wrap to body.
HEAT TIME
From 1.5 hours (HIGH) to 4 hours (WARM). TIMING IS DEPENDENT ON QUALITY OF BATTERIES.
WASHING INSTRUCTIONS
DO NOT DRY CLEAN! DO NOT BLEACH! DO NOT USE WRINGER!
- Remove controller from pad.
- Fasten the hook and loop on the wrap to itself, fold nicely and place wrap in laundry bag.
- Machine wash wrap in cold water on gentle cycle, or hand wash. Line or air dry and do not place in an electric dryer.
TROUBLESHOOTING
Unit does not turn on:
- Make sure you are using rechargeable NiMH batteries.
- Make sure batteries are charged completely.
- Make sure batteries are placed in the controller in the correct orientation.
- Make sure connector plug is firmly pressed into controller.
Unit is not warm enough:
- Batteries need replacement
- Batteries need to be charged.
One light flashing automatically:
- Batteries need to be recharged.
