Evoca Scout Pilot Receiver TV Set User Manual

Evoca Scout Pilot Receiver TV Set User Manual

WHAT’S IN THE BOX

Here’s what you’ll need:

• An available power outlet for Pilot.
• If your antenna is powered, a second outlet will be required.
• An available HDMI input on your TV (take note of the HDMI input number).
• The remote that came with your TV.
• An antenna with a coax cable (either your own or one you ordered).
• A good initial location to place your antenna.

Still have questions?

Scan the QR Code or visit Evoca.tv/SetUp or call

SETUP

SET UP YOUR ANTENNA & INTERNET.

• Mount your antenna.
• If you already have your own antenna installed, skip to Step 2.
• Identify an initial location to place your antenna – upper interior wall, on a window or exterior wall is usually the best.
• Mount your antenna (keep in mind that you may want to move your antenna after we check your reception in POWER UP PILOT, Step 3).
• Refer to the antenna installation instructions now, but don’t connect the cable to your TV. You’ll read more about that in a moment.
• Connect your antenna to Pilot.
• Using the coax cable connect your antenna to the antenna connector on Pilot (Diagram 1).
• Choose an internet connection to Pilot.
• If using your Wi-Fi network, you can skip this step. You’ll connect later as a part of the on-screen set-up.
• If connecting Scout directly to a modem or router, do so now using your Ethernet cable (Diagram 2).

CONNECT PILOT TO YOUR TV.

Connect HDMI cable.

• Connect the supplied HDMI cable from the HDMI port on Pilot to the HDMI input that you’ve identified on your TV (Diagram 3).
• Some TVs have multiple HDMI ports, so take note of which HDMI input you are using.
• If you’d like, you can write it down here HDMI #___________ 2 Turn on your TV.
• Using your TV’s remote control, turn on the TV and select the HDMI input you noted in Step 1C.

POWER UP PILOT.

Connect Pilot to power.

• Using the Pilot power supply and power cable, connect Pilot to the power supply.
• Plug the power supply into a working power outlet.
• After a few seconds you should see the light on the bottom of your Pilot to begin blinking.
• Insert the batteries supplied with your Pilot into the remote by sliding down the lower back panel of the remote and insert the batteries as in (Diagram 6).

Follow the on-screen instructions.

• If everything is good to this point, you should see an Android TV logo on your TV screen. Pilot will then fly you through the rest of the setup on screen.
• If you don’t see the Android TV logo followed by instructions, make sure your TV is set to the HDMI input that Pilot is hooked up to. Then, make sure that your cables are connected.

Make sure Pilot has found your channels. (Don’t worry, you are almost there).

• When all of the setup steps are complete, the bottom of your screen should look something like this (Diagram 4) with navigation including Help, Messages, Settings, Favorites, Watch TV and Guide (Diagram 5).
• Select Guide ( ) and scroll through the channels in your guide. Local channels you should expect to see include CBS, NBC, ABC and Fox.
• You should also see your Evoca TV channels, such as the Weather Channel, Bloomberg and NFL Network.
• If you see all of these channels, you Pilot should have a solid green light on the bottom and you should be all set to enjoy Evoca TV. If you didn’t get all of the channels that you expected, follow the instructions for re-scanning for channels.

PROGRAM YOUR EVOCA REMOTE.

• Reference the remote codes on the back page of this guide and note the codes for your brand of TV.
• On your new Evoca remote press the TV Input button ( ) and the OK button ( ) together and hold for 2 seconds.
• Once the light on the remote is solid, release those buttons and enter the three digit code for your brand of TV.
• Test the Volume and power buttons. If it controls your TV, you are all set. If it doesn’t repeat Step B with the next code for your TV.

Re-scanning for Channels

If you didn’t get all of the channels you were expecting in Power Up Pilot, Step 3, or at any time you aren’t receiving the reception you expect, try the following steps:

• Move your antenna to a new location (keep in mind that higher is usually better and a window is sometimes better than a wall).
• Using your Pilot remote, go to homescreen>settings>channel scan>channel scan and then scan. This will take a few minutes, but Pilot will scan all available frequencies and look for all of your channels.
• If you have all of the channels you’d expect (see Power Up Pilot, Steps 3B & 3C), permanently mount your antenna where it is and you are done.
• If you still don’t have all of your channels, go back to Power Up Pilot, Step 3 and try again. Depending on the location and type of home as well as the type of antenna that you are using, it may take a few tries to get the best possible signal. If you get stuck, please visit www.evoca.tv/setup or call us at 877-EVOCATV between 9am and 8pm MST. For after hours support, contact support@evoca.tv.

REMOTE CODES

TV BRAND CODES

AUDIOVOX 576, 720, 800, 807, 808
BROKSONIC 338, 450, 702, 707, 738, 742
COBY 154, 232, 769, 770, 771, 788, 817
CRAIG 129, 242, 576, 606, 754
DAEWOO 813, 99, 698, 711, 715, 725, 754, 762
DYNEX 314, 1, 128, 179, 247, 335, 336, 337, 338, 339, 340, 341, 625
ELEMENT 294, 154, 239, 129, 513, 586, 513
EMERSON 563, 154, 682, 686, 690, 715, 335, 376, 576, 672, 689, 702, 709, 745, 814
FUJITSU 745, 805
FUNAI 335, 340, 563, 682, 686, 690, 709, 745, 576, 754
GE 396, 122, 154, 668, 705, 755, 816
GOLDSTAR 99, 154, 682, 709
HAIER 297, 589, 154, 157, 175, 513, 179, 628
HISENSE 154, 296, 386, 513, 157, 635
HITACHI 250, 167, 346, 513, 682, 152, 289, 709, 717
INSIGNIA 314, 340, 339, 337, 294, 341, 513, 680, 128, 690, 782, 338, 179, 1, 154, 335, 336, 625
JC PENNEY 99, 157, 360, 396, 668, 735, 755
JVC 245, 152, 157, 282, 167, 513, 692
LG 154, 682, 717, 99, 396, 709
MAGNAVOX 368, 1, 150, 309, 335, 340, 513, 686, 690, 695, 811
MITSUBISHI 99, 750, 717, 745
NEC 602, 99, 153, 264, 374, 472
PANASONIC 12, 370, 651, 694, 360, 775
PHILIPS 368, 1, 513, 690, 686, 717, 740
PHILIPS-MAGNAVOX 1, 792, 150, 695

TV BRAND CODES

PIONEER 289, 685, 153, 495, 724
POLAROID 189, 464, 277, 1, 122, 129, 179, 360, 642, 763, 810
PROSCAN 282, 157, 154, 129, 294, 333, 347, 374, 512, 601, 655, 458, 577, 396, 189, 368, 627, 632, 678, 758, 764
QUASAR 1, 12, 512, 668, 671, 714
RCA 630, 333, 638, 122, 150, 154, 157, 289, 346, 347, 358, 396, 458, 483, 513, 577, 626, 646, 673
ROKU TV 513, 635, 150, 314
SAMSUNG 157, 739, 2, 158, 737, 759, 99, 360, 374, 784
SANSUI 338, 129, 335, 347, 450, 742
SANYO 376, 155, 513, 654
SCEPTRE 392, 374, 282, 790
SEARS 1, 150, 154, 157, 335, 360, 376, 396, 450, 591, 686, 690, 745
SEIKI 294, 154, 239, 360
SHARP 154, 249, 150, 634, 513, 470, 635,
SONY 374
SUPERSONIC 129, 188, 641, 644, 647, 672
SYLVANIA 563, 340, 686, 709, 1, 198, 335, 338, 631, 682, 686, 690
SYMPHONIC 335, 576, 682, 686, 690, 709
TCL 346, 513, 382, 1, 309, 512
TOSHIBA 360, 122, 377, 294, 450, 455, 670, 737, 153, 376, 472, 717, 785
VIEWSONIC 378, 141, 309, 543, 578, 590, 591, 592, 593, 594, 595, 1, 289, 549, 629
VIZIO 371, 628, 591, 594
WESTINGHOUSE 374, 157, 277, 294, 513, 594, 612, 639, 780, 513
WHITE-WESTINGHOUSE 338, 392, 483, 682, 699, 709
ZENITH 747, 38, 150, 152, 154, 603, 669, 682, 695, 709, 713, 727, 737, 742, 804, 814, 722

REFRENCE LINK

https://www.evocagroup.com/en