RAM Mounts RAPSB187MA14 Plastic Magellan Mount User Instructions
Parts Index
- Attach (C) adhesive rubber pad to (B) strap.
Cut out measuring strip shown on the right. Wrap the strip around area where RAM® EZ-Strap is to be attached until the “ALIGN EDGE ™ WITH ZONE” end aligns with one of the “Short, Medium, or Long” segments to determine appropriate strap length. Once correct segment is determined, use scissors to cut only along one of the shown reference lines “ ” just pass the corresponding groove.
With (C) adhesive pad facing up, insert (D) pin half way inside hinge of (B) strap. Insert (B) strap with protruding (D) pin into the backside right slot of (A) base. While pressing (B) strap firm against (A) base, press pin through the left slot using a flat head screwdriver. Adhere (E) adhesive pad.
Place RAM on surface and feed the strap through ® EZ-Strap™ (A) base until strap clicks into base. Hold the RAM® EZ-Strap in ™ place as you pull the strap to tighten.
Cut out measuring strip shown on the right. Wrap the strip around area where RAM® EZ-Strap is to be attached until the “ALIGN EDGE ™ WITH ZONE” end aligns with one of the “Short, Medium, or Long” segments to determine appropriate strap length. Once correct segment is determined, use scissors to cut only along one of the shown reference lines “ ” just pass the corresponding groove.
With (C) adhesive pad facing up, insert (D) pin half way inside hinge of (B) strap. Insert (B) strap with protruding (D) pin into the backside right slot of (A) base. While pressing (B) strap firm against (A) base, press pin through the left slot using a flat head screwdriver. Adhere (E) adhesive pad.
Place RAM on surface and feed the strap through ® EZ-Strap™ (A) base until strap clicks into base. Hold the RAM® EZ-Strap in ™ place as you pull the strap to tighten.
FCC Warranty
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference.
