Atrix Audio Bundle for Wireless Headphone & Speaker User Guide
Need Help?
Have any questions or comments? Need help getting set up? Contact us at https://care.gamestop.com
What’s Included
- Wireless Headphone
- 3.5mm Aux Cable
- USB-A to Micro-USB Charging Cable
(Note: charging cable does not transfer data)
Headphone LED Indicators
- Rapid Flashing Red and Blue – Pairing
- Flashing Blue – Paired
- Flashing Red – Low Battery
- Solid Red – Charging
- No Red light – Charging complete
Pairing the Headphones
- Pairing:
- Power ON the headphones. When pairing for the first time the headphones will automatically enter pairing mode. The Indicator light will flash red & blue on the right side of the headphones.
- Use the bluetooth settings on your device to pair with Atrix Headphone. When the indicator lights flash blue every 5 seconds the pairing was successful.
Note: Hold power button for 3 seconds to power on/off. - Re-enter Pairing:
- To re-enter pairing mode disconnect from your device using the bluetooth menu.
- To re-enter pairing hold the volume up and down buttons for 3 seconds to disconnect, the light will flash blue and red. Use your device to connect using the pairing instructions.
Charging the Headphones
- Plug the Micro-USB end of the charging cable into the headphone.
- Plug the USB-A end of the charging cable into a UL compliant power supply of at least DC 5V 500mA.
- A full charge requires approximately 3 hours.
- The red light will turn blue when charging is complete.
Noted: headphones can not playback when charging.
AUX Setup
- The headphone comes with an AUX cable
- Plug the AUX cable into the headphones and into your device.
EQ Mode
- Press EQ Mode button once to turn on EQ mode and enhance the bass effect.
Important Safety Instructions
WARNING When using this product, basic precautions should always be followed, including the following:
Read these instructions carefully. All cautions and warnings should be followed. Protect equipment from humidity. Do not use chemical detergents to clean your device, use a soft dry cloth. To avoid damage from electrical peaks unplug the device when it is not in use. If one of the following situations arise, equipment has to be checked by qualified service personnel:
- Liquid has penetrated into the equipment.
- Equipment has been exposed to humidity.
- Equipment has been dropped and/or is damaged.
- Equipment has obvious sign of breakage.
- Equipment does not work well or you cannot get it working according to user’s manual.
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
REFERENCE LINK
