AmazonBasics B074MWKSLX Ceramic Space Heater User Guide
Contents:
Before getting started, ensure the package contains the following components:
- Front grill
- Power indicator
- Power cord with power plug
- Thermostat knob
- Power knob
- Tip-over switch
MPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before using this product.
- Keep this instruction manual for future use. Should this product be passed on to a third party, then this instruction manual must be included.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from trafficked areas and where it will not be tripped over.
- To disconnect heater, turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
CAUTION
Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- Do not pull the power plug out of the electrical outlet by the power cord and do not wrap the power cord around the appliance.
- Connect the power plug to an easily reachable electrical outlet so that in case of an emergency the appliance can be unplugged immediately. Pull the power plug out of the electrical outlet to completely switch off the appliance. Use the power plug as the disconnection device.
- Disconnect the power plug from the electrical outlet when not in use and before cleaning.
- Always turn the appliance off before disconnecting the power plug.
- The heater must not be located immediately below a socket-outlet.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
- In order to avoid damages to the appliance, always use it in an upright position.
- When using this appliance for the first time, a slight, temporary odor could develop. This is due to manufacturing residues, which are burning off. Ensure for sufficient room ventilation.
- Should a fire break out, pull the plug out of the power outlet or otherwise separate the appliance from the power source first before using appropriate fire-fighting measures.
Intended Use
- The heater is intended for temporarily heating residential rooms.
- The heater is intended solely for indoor non-commercial use.
- Use the product only as described in this manual.
- No liability will be accepted for damage resulting from improper use or non-compliance with this manual.
Before First Use
- Carefully remove all packaging materials and retain for future use.
- Check for transport damages.
- Clean the product ( Cleaning and Maintenance).
- Place the product on a stable, flat and heat-resistant surface.
- Set the power knob to (Off) position before plugging the product into the power source.
- Plug the product into a suitable power source.
Operation
CAUTION
Risk of burns! The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
NOTICE
The power indicator stays on as long as the power plug is connected to the power source.
Set the power knob to the desired setting:
- The heater is off.
- only. No heating.
- Heating mode – Low volume
- Heating mode – High volume (1500 Watts).
- Max Temperature
- Min Temperature
Overheating protection.
The product will automatically shut-off when it overheats. Unplug the product from the power source and let it cool for at least 30 minutes.
Thermostat control
- Set the power knob to the or setting.
- Set the desired temperature using the thermostat knob.
- The heater will now start operating. It will reach and then maintain the pre-set temperature.
Tip-Over switch
The heater is designed to automatically shut-off when tipped over. When returned to the proper upright position, the heater will resume normal operation.
Overheat shutdown
The product will automatically shut-off when it overheats. Make sure the heater is clear of all obstructions. Reset the product to resume normal operation. (see Troubleshooting).
Cleaning and Maintenance
- Clean the product with a slightly damp cloth. Do not allow water or other liquids enter the product’s interior.
- Do not use abrasives, harsh cleaning solutions or hard brushes for cleaning.
- Let all parts dry afterwards.
Storage
- When not in use, store the product in its original packaging.
- Do not wrap the cord around the product.
- Store the product in a cool, dry place.
Troubleshooting
If the heater does not operate:
- Ensure that the circuit breaker or fuse is working properly.
- Set the power knob to (Off) position and unplug the product from the power source.
- Plug another product to the power source to confirm that it’s working.
- Let the heater cool for 30 minutes.
- Move all obstructions from the surroundings of the heater.
DANGER
Risk of electric shock! Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.
Disposal
Devices marked with this symbol must be disposed of separately from your household waste, as they contain valuable materials which can be recycled. Proper disposal protects the environment and human health. Your local authority or retailer can provide information on the matter.
REFERENCE LINK