Nokia (BH-205) Lite Wireless Earbuds Quick Start Guide
What’s in the box
- Charging Case
- Earbuds (L/R)
- Ear Tips (S/M/L)
- USB Type-C cable
- Quick Start Guide
Product overview
- Charging contacts (R)
- Charging contacts (L)
- Battery status LEDs
- USB Type-C port
- Touchpad
- Microphone / LED indicator light
- Ear tip
Power on
When you take the earbuds out from the charging case, the earbuds will turn on and pair with each other automatically. When they have successfully paired, the LED indicator light of the right earbud will flash blue and red alternately and the earbuds are ready to connect with your Bluetooth® device.
Pairing
– The LED indicator lights of the earbuds will flash blue when they are
successfully connected with your Bluetooth device.
– After the initial pairing, the earbuds will automatically connect with your
Bluetooth device whenever taken out of the charging case.
Charging
- Charge the charging case:
Connect the USB Type-C cable to a power source to begin charging. The battery status LEDs show the current battery status.
- Charge the earbuds:
Earbuds LED indicator lights turn red when charging, and turn off when fully charged. If the earbud is low in battery power, the LED indicator light will flash red every 5 seconds.
Touch Controls
Troubleshooting
Problem
Unable to turn on earbuds
No sound after paired
Turn off automatically
Failing to charge
No light on the case during charging
Hearing echoes
Having noise during a call / Sound skips frequently
Sound is too soft
Cannot turn on the earbuds after taken out from the charging case
Reason
Battery is low
Not pairing properly
Battery is low
Error with power supply
Error with power supply
Volume is too loud or the environment is too noisy
Environment interference caused or distance between earbuds and mobile is too far
Low volume
Charging case is low in battery
Solutions
Pesthe abus again or
Charge the earbuds for 1.5-2 hours
Perform a hardware reset
Check whether the charging cable is plugged in. Ensure the switch button is turned on.
Adjust the volume or go to a quieter place
Change locations or reduce the distance between the earbuds and devices
Increase the volume
Charge tose tort-sours
You can use a single earbud. If the earbuds have been paired with your Bluetooth device before, it will automatically connect with your device when taken a single one out of the charging case.
Product and safety information
Remote control functions may vary depending on the model of your device and application. Sound track instructions do not respond to iOS devices. Since devices with Bluetooth wireless technology communicate using radio waves, they do not need to be in direct line-of-sight. Bluetooth devices must, however, be within 10 meters (33 feet) of each other, although the connection may be subject to interference from obstructions such as walls or from other electronic devices. Frequency Band: 2400 MHz – 2485 MHz
For your safety
Important: Read these simple guidelines. Not following them may be dangerous or against local laws and regulations. For further info, read the complete user guide.
- Switch off in restricted areas
Switch the device off when a Bluetooth headset use is not allowed or when it may cause interference or danger, for example, in aircraft, in hospitals or near medical equipment, fuel, chemicals, or blasting areas. Obey all instructions in restricted areas. - Interference
All wireless devices may be susceptible to interference, which could affect performance. Batteries, chargers, and other accessories Use only batteries, chargers, and other accessories approved by HMD Global Oy for use with this device. Do not connect incompatible products. - Protect your hearing
To prevent possible hearing damage, do not listen at high volume levels for long periods. - Hearing
Warning: When you use the headset, your ability to hear outside sounds may be affected. Do not use the headset where it can endanger your safety. - Small children
Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
Take care of your device
- Handle your device with care. The following suggestions help you keep your device operational.
- Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits.
- Do not use or store the device in dusty or dirty areas.
- Do not store the device in high temperatures. High temperatures may damage the device or battery.
- Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form inside the device and damage it.
- Do not open the device other than as instructed in the user guide.
- Do not drop, knock, or shake the device or the battery. Rough handling can break it.
- Only use a soft, clean, dry cloth to clean the surface of the device.
- Do not paint the device. Paint can prevent proper operation.
REFRENCE LINK
https://www.mynokia.com/headphones/nokia-lite-earbuds-bh-205/
