Hoover Blade MAX AutoVac Cordless Hand Held Vacuum Cleaner User Guide

Hoover Blade MAX AutoVac Cordless Hand Held Vacuum Cleaner User Guide

IMPORTANT SAFETY INSTRUCTIONS

1. Fully assemble product prior to use.
2. Do not use charger outdoors.
3. Do not expose to rain. Store indoors.
4.  Do not allow to be used as a toy. Not intended for use by children age 12 and under. Close supervision is necessary when used by or near children. To avoid injury or damage, keep children away from product, and do not allow children to place fingers or other objects into any openings.
5. Use only as described in this user manual. Use only HOOVER® recommended attachments and parts.
6.  Do not use charger with damaged cord or plug. If product or charger is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1-800-406-2005 prior to continuing use.
7.  Do not pull or carry charger by cord. Keep cord away from heated surfaces.
8.  Do not unplug charger by pulling on cord. To unplug charger, grasp the plug, not the cord.
9.  Do not handle charger, plug, or charger terminals with wet hands
10. Put product away after use to prevent tripping accidents

CHARGING YOUR PRODUCT

1. Plug in the charger, then attach the battery pack to the charger by aligning the ribs on the battery pack to the
   grooves in the charger.
2. Slide the battery pack into the charger.
   NOTE: The lights on the battery will show the state of charge. If the light on the charger flashes red, there is an
   error with the battery or the charger. If this occurs, disconnect and reconnect the battery or call customer service for support. Once charge is complete, lights on the battery and charger will turn
3. To remove the battery pack, press the latches and pull up. During charging, the pack and ambient temperature should be between 32 to 86° F (5 and 30° C). The charger will sense if the pack, or ambient temperature, is too cold or too hot, and will return an error code.

ACCESSORIES

1. Connect Extension Hose to handheld portion.
2. Choose your attachment to connect to
   Hose
   • Flexi-Crevice Tool
   • Upholstery Tool
   • Tough Dirt Tool
   • Dusting Brush
3. Click grey button on handheld to release hose
4. Click grey button on hose to release attachment

ASSEMBLY

1. Rock the dirt cup into the handheld.
2. Push the reach wand down onto the powered nozzle until it clicks into place.
3. Push the handheld down onto the reach wand until it clicks into place.

NOTE: Fully charge battery before first use. This will take 3-4 hours. Due to federal regulations, the battery does not come fully charged.

TOUGH DIRT TOOL

1. Tough Dirt tool attaches directly to the upholstery tool by aligning arrows on both tools
2. Remove tough dirt tool attachment by pulling the tab with arrow

MOTORIZED PET TOOL

1. Attach directly to handheld portion
2. Increase suction by using + mode
3. Click grey button to release attachment

MAINTENANCE

GENERAL MAINTENANCE

IMPORTANT: Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use a clean cloth to remove dirt,
dust, oil, grease, etc.

EMPTYING THE DIRT CUP

1. Remove the battery pack.
2. Pull the filter away and tap to remove dirt. Rinse filter under warm water until water is clear. Allow filter to dry for 24 hours before reinserting.
3. Hold the dirt cup over a trash bin and press the dirt cup release button to empty. Close the dirt cup, then replace it by rocking it back into place.

CLEANING THE FILTER AND CYCLONE

1. Pull open the lid of the dirt cup to access the filter. To clean the cyclone, lift to remove. Clean dirt and debris.
2. Push down the latch on the dirt cup to release. Tilt and lift to remove the dirt cup from the stick vac
3. Hold the dirt cup over a trash bin and press the dirt cup release button to empty. Close the dirt cup, then replace it by rocking it back into place.

REFERENCE LINK

https://hoover.com/

Buy Related Product on Amazon

Buy on Amazon