BN-LINK IN WALL COUNTDOWN TIMER USER MANUAL
IMPORTANT PRODUCT INFO
- Single Pole: The timer will control devices from one location. Do not use in a 3-way application where multiple switches control the same device.
- Direct Wire: This timer is only intended to be installed into an electrical wall box.
- Tool Required: One (1) standard flathead screwdriver (not included).
INSTALLATION INSTRUCTIONS
- Turn off power at the circuit breaker or fuse box before uninstalling the existing device or installing a new timer.
- Choose desired faceplate (white or metallic) and knob (white or black) to install on the timer.
- a. To remove the current knob & faceplate, firmly pull the knob away from the timer.
- b. To loosen the washer, rotate the attached faceplate counter-clockwise, unscrewing the washer to free the faceplate.
- c. Attach the desired faceplate and then rotate the washer clockwise into place with your fingers. Tighten by rotating the attached faceplate clockwise, screwing the washer into place until secure.
- d. To install desired knob, position the knob facing upward and align the flat edge of the post into the square receptacle on back of knob. Press the knob down onto the post until snug against the faceplate.
Continued
- Remove the existing wall plate and switch from the wall box.
- Make sure the following 2 wires are present in the wall box. (see Diagram A).
- a. 1 Hot Wire from circuit breaker box.
- b. 1 Load the Wire to the device to be powered. If these are not present, this Timing Device will not function properly. Additional wiring to the wall box will be required before installation of this timer can be completed.
- Strip wires 1/2 inch. (see Diagram A).
- Use the included wire nuts and securely twist them together to attach the timer wires to the building wires. NOTE: Either black timer wire can be attached to either “hot” or “load” wire (see Diagram A)
- Insert timer into wall box (2-1/2 inch) being careful not to pinch any wires. Be sure the timer is inserted correctly with the faceplate text reading upright. (see Diagram B)
- Fasten the timer to the wall box using the screws provided. (see Diagram B)
- Place a rocker/decorator wall plate (not included) around the timer face. (see Diagram B)
- Restore power at the circuit breaker or fuse box.
OPERATING INSTRUCTIONS
To activate COUNTDOWN PROGRAMMING Turn the dial clockwise to any time interval (2 to 60 minutes). The attached devices will turn ON. Countdown starts immediately for the timed duration selected. Once the time runs out, the attached devices will turn OFF.
IN CASE OF POWER FAILURE
The timer will stop operating if the power goes out. It will continue counting down when the power is restored so check to be sure that the time that is set is still correct. If not, reprogram as desired following the OPERATING INSTRUCTIONS above.
TROUBLESHOOTING
WARNING
To avoid fire, shock, or death, turn off the power at the circuit breaker or fuse box before wiring. Installation by a licensed electrician to local, state, and national codes is recommended. For INDOOR use only. Do not use it to control appliances.
SAFETY INFORMATION & SPECIFICATIONS
THIS TIMER IS FOR USE WITH A 120 V AC POWER SOURCE. 125 V AC / 60 Hz DO NOT ATTACH A DEVICE THAT EXCEEDS THE UNIT RATINGS: 20 A / 2,500 W Resistive (General Purpose) 8 A / 1,000 W Tungsten (Incandescent) 5 A / 625 W Ballast (Fluorescent) 1 HP (Horsepower Motor).
HELPFUL TIPS
To program a time interval below 10 minutes, first turn the dial clockwise past 10 and then counter-clockwise to the preferred time.
