BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE featured img

BN-LINK BND-60/U57 PHOTOCELL COUNTDOWN TIMER GUIDE

BN-LINK logo

BN-LINK BND-60/U57 PHOTOCELL COUNTDOWN TIMER GUIDE

BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE prduct img

FEATURES
7 Modes: On, On from Dusk to Dawn, On at dusk, and remain on for 2, 4, 6, or 8 hours, Off.

INSTALLATION INSTRUCTIONS

BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE fig 1

  1. Install the unit on a flat surface. Using a screw or hook (not included) secure the mounting tab at the top of the timer to a wall or post.
  2. Plug the unit into an electrical outlet. Use an outdoor-rated 3-pronged grounded electrical outlet. Do not use extension cords to connect the timer to the power source.
  3. Set the desired operating mode. Rotate the dial either clockwise or counter-clockwise to align the white mark with the mode.
    BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE fig 2BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE fig 3
  4. Attach up to two devices to the unit. Plug the devices into the outlets on the bottom of the timer.

HELPFUL TIPS

  • This unit is weather-resistant and rated for outdoor use. This timer operates using a light-sensitive photocell that senses when the environment is getting dark (dusk) or light (dawn).
  • Once programming activates at dusk in the 2hr, 4hr, 6hr or 8hr mode, the program cycle will complete before the timer resets.
  • When set to ON, the unit will provide continual power to attached devices until the timer is switched to OFF, or to any of the other operating modes.
  • The POWER indicator will glow red when the timer programming is activated and power is being provided to attached devices.

TROUBLESHOOTING

BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE fig 4

BN-LINK BND-60U57 PHOTOCELL COUNTDOWN TIMER GUIDE fig 5

PROBLEM:
The timer is not turning off after 2/4/6/8 HR mode.

Please follow these instructions to troubleshoot the issue:

  1.  Please plug the timer into the wall.
  2. Place a piece of BLACK electrical tape over the white photocell sensor on the front of the unit
  3. Place the unit on a 2-hour function (Within 18 seconds of darkness your unit should activate).
  4. Come back to the timer in 2 hours and confirm if your appliance is off.
  5. If it is off, please place your timer in a dark location as ambient lighting (car lights, window lights, etc) may be affecting the sensor.

A WARNING

Risk of Electric Shock

  • Keep children away
  • Unplug the timer before cleaning
  • Fully insert plug
  • Do not use near-standing water.

Risk of Fire

  • Do not use to control appliances that contain heating elements (cooking appliances, heaters, irons, etc.)
  • Do not exceed electrical ratings.

SAFETY INFORMATION & SPECIFICATIONS

FOR USE OUTDOORS AND MUST BE PLUGGED INTO A GFCI (GROUND FAULT CIRCUIT INTERRUPTER). This is a “GROUNDED” device. The male plug contains a ground pin and is only intended for use with a three-pronged grounded outlet. This device is for use with a 125 VAC power source.

Electrical Ratings:

  • 125VAC/60Hz
  • 5A 625W Tungsten and Ballast
  • 15A 1875W Resistive

BN-LINK INC.

  • 12991 Leffingwell Avenue, Santa Fe Springs
  • Customer Service Assistance: 1.909.592.1881
  • E-mail: support@bn-link.com
  • Http://www.bn-link.com
  • Hours: 9 AM – 5 PM PST, Mon – Fri
  • Designed in California Made in China

REFERENCE LINK

DOWNLOAD PDF

BN-LINK BND-60/U57 PHOTOCELL COUNTDOWN TIMER GUIDE

Leave a Reply