Ozeri BP2M Wrist Blood Pressure Monitor User Manual
Introduction
Thank you for purchasing an Ozeri Fully Automatic Wrist Blood Pressure Monitor. The device uses the oscillometric method of blood pressure measurement. This method detects the movement of your blood through your brachial artery and converts your blood pressure into a digital reading. You can access the stored data simply by pressing the MEMO button.
Important Safety Information
To assure the correct use of this product, basic safety measures should always be followed, including the precautions listed below:
- Operate this device only as it is intended. Do not use this device for any other purpose.
- This device is intended for use in measuring blood pressure and heart rates for adults only. Do not use it on infants or persons who cannot express their intentions.
- Do not use a cellular phone near this device. Cell phones may inhibit the accuracy of this device.
- Do not disassemble or attempt to repair this device or any of its components. Doing so will void the warranty.
Understanding Blood Pressure
Values This device refers to a blood pressure Organization (WHO) and the International Society of Hypertension (ISH).
Suggestions Before Measuring Blood Pressure
- Make sure the wrist cuff is at heart level.
- Stress raises blood pressure.
- Wait 2-3 minutes before retaking your blood pressure measurement.
- Keep the records for your physician and refer to your physician for guidance.
Remember that one reading does not provide a true blood pressure value; only long-term records will reveal a more accurate picture of your blood pressure.
Device Descriptions
Description of LCD Display Symbols
- Remove the battery cover by sliding it in the direction indicated by the arrow.
- Replace the battery cover.
Programming Date and Time
- Press and hold the TIME button for 2 seconds until the display shows 2012 and starts to
- Press the MEMO/▲ button or SCAN/▼ button until the number representing the current Year appears on the screen. Note: pressing and holding the MEMO/▲ or SCAN/▼ button for about 2 seconds will cause Year to increase or decrease at a faster speed.
- Follow the same instructions as above to set the Month, Date, Hour, and Minute settings.
Note: After replacing batteries, always proceed to use the blood pressure monitor.
Using the Wrist Cuff
- Remove all clothes from your arm allowing the cuff to make direct contact with your skin.
- Hold your left arm in front of you with your palm facing up.
- As shown in the image below, enclose the wrist cuff leaving 1/4”~1/2” (0.6 cm – 1.3 cm) between the edge of the cuff and the palm of your hand.
- Hold the bottom part of the cuff and wrap it comfortably around your wrist. The top and bottom edges of the cuff should be tightened evenly around your wrist. (Do not pull strongly on the cuff. Do not apply the wrist cuff too tightly.)
Measuring Your Blood Pressure
- If no specific user is chosen, the default user is always “1”.
- Then press the START button to take a measurement. The cuff will automatically.
- Healthy according to the World Health screen is green, orange, and red.
What is Arrhythmia?
A heartbeat is stimulated by electrical signals that cause the heart to contract. Arrhythmia is a condition where the heartbeat rhythm is a system that drives the heartbeat. Typical symptoms are skipped heartbeats, premature contraction, and an abnormally rapid (tachycardia) or slow (bradycardia) pulse. This can be caused by heart disease, aging, physical predisposition, stress, lack of sleep, fatigue, etc.
The appearance of an irregular heartbeat symbol does indicate arrhythmia. Arrhythmia and other heart conditions can only be properly diagnosed by a doctor through a medical examination.
Using the Memory Feature
The measured blood pressure and pulse readings are automatically stored in the memory. This blood pressure monitor will save the most recent 1197 measurements in memory (399 measurements for 3 users).
Recall/Review previous measurements
Press the MEMO/▲ button to recall/review the most recent measurement. Continue to press the MEMO/▲ button to review each previous measurement. The Systolic blood pressure, Diastolic blood pressure, pulse, and Date/Time of measurement will display for each measurement.
Press the MEMO/▲ button repeatedly to cycle through previous measurements. The measurement number will be displayed as M 01, M 02, M 03, M 04, … etc. Scanning previous measurements in 10 measurement increments: press SCAN/down to recall/review the measurements in 10 measurement increments: from M10, M20, M30, … etc.
Using the Average Feature
The blood pressure monitor provides an average blood pressure reading calculated based on the total measurements stored in memory. To activate the average feature, press the MEMO/▲ button. The symbol AVG will appear on the screen along with your average systolic, diastolic, and pulse readings.
TROUBLESHOOTING
| TROUBLESHOOTING | ||
| Condition | Cause | Solution |
| With batteries installed, the device is turned on and nothing appears on the screen. | • Batteries are not installed properly. • Batteries are dead. | • Ensure batteries were installed with correct +/- polarity. • Replace with new batteries. |
| Condition | Cause | Solution |
|
fails or does properly. | Cuff is not properly attached to the wrist | Ensure proper wrist position and that the applied to wrist leaving 1/4”~1/2” (0.6 cm – 1.3 cm) between the edge of the cuff and the palm of hand. |
|
| Replace batteries taking care to ensure device
Alkaline batteries. |
| Condition | Cause | Solution |
|
fails or does properly. | Cuff is not properly attached to the wrist | Ensure proper wrist position and that the applied to wrist leaving 1/4”~1/2” (0.6 cm – 1.3 cm) between the edge of the cuff and the palm of hand. |
|
| Replace batteries taking care to ensure device
Alkaline batteries. |
| The blood pressure monitor displays different results that vary too much. | Blood pressure can vary based on stress, time of day, exercise, consumption of alcohol, smoking, tightness of cuff, and other | |
| variables. A single | ||
| measurement | ||
| does not provide | ||
| an accurate | ||
| indication of blood | ||
| pressure. Several | ||
| readings are | ||
| recommended. | ||
| Always wait | ||
| 3 or more | ||
| minutes between | ||
| measurements. |
SPECIFICATIONS
| Model No. | BP2M |
| Display | LCD Digital Display |
| Measurement Method | Oscillometric method |
| Measurement Range | Pressure: 20~280mmHg Pulse: 40~190 / minute |
| Accuracy / Calibration | Pressure: ± 3mmHg or 2% of reading Pulse: ± 5% of reading |
| Memory capacity | 399 measurements per user (total 3 users) |
|
pump | |
| Automatic liner pressure
| |
| Pressure Release | Automatic exhaust valve |
| Sensor | Semiconductor pressure sensor |
| Power Supply | 3V DC (2 “AAA” alkaline batteries) |
| Measuring Interval | 1 mmHg |
| Operating Temperature/ Humidity | +10oC~+40oC (50 0F~104 0F) 40%~85% R.H. maximum |
| Storage Temperature / Humidity | -20oC~+50oC (-4 0F~122 0F) 15%~85% R.H. maximum |
| Battery Life | Approx. 250 uses (alkaline batteries) |
| Unit Weight | Approx. 105 grams (not including batteries) |
| Cuff Size | Wrist Circumference approx. 135~195mm (5 1/4~ 7 3/4 inch) |
| Unit dimensions | Approx. 74 (l) x 72 (w) x 25 (h) mm |
| Accessories | Storage Case, Instruction Manual |
Care and Maintenance
Care
- Clean the unit with a soft dry cloth. Do not use any abrasive or volatile cleaners.
Maintenance
- Clean the unit with a soft dry cloth. Do not use any abrasive or volatile cleaners.
- Do not wet the cuff or attempt to clean the cuff with water.
- Store the unit in a clean and dry indoor location. Do not subject the unit to extreme hot or cold temperatures, humidity, and direct sunlight.
- Remove the batteries if the unit will not be used for 3 months or longer.
WARRANTY INFORMATION
Your Ozeri Blood Pressure Monitor, excluding the wrist cuff, is warranted to the original owner for 5 years from the date of purchase against defects in material and workmanship under normal use. The wrist cuff is warranted to the original owner for 1 year to be free from defects in material and workmanship under normal use.
Should your blood pressure monitor and/or wrist cuff appear defective within the applicable period from the date of purchase, return the defective unit, freight prepaid along with an explanation of the claim to Ozeri. Please pack carefully to avoid damage in transit. This warranty extends only to personal use and does not extend to any product that has been used for commercial use, or use which is not intended.
This warranty is not transferable. Ozeri is not responsible in any way for damages, losses, or inconveniences caused by equipment failure caused by user negligence, abuse, or use not in accordance with the “User Guide” or any additional safety, use, or warnings included in the product materials.
- Improper or inadequate maintenance. use.
- Damage in return transit.
- Unsupervised use by children under 18 years of age
- Ozeri Customer Service
- Customer service: 1-877-299-1296 (USA)
- Email: support@ozeri.com
REFERENCE LINK
https://ozeri.com/bath-and-personal-care/ozeri-blood-pressure-monitors
