Table of contents
show
FireFriend BQ-6850 Charcoal Barbecue Tristar User Guide
SAFETY INSTRUCTION
- Do not use spirit ,petrol or comparable fluids for lighting or re-lighting.
- The barbecue has to be installed on a secure and level surface.
- Before the first cooking the barbecue shall be heated up for at least 30 minutes until the fuel is red hot.
- Do not cook before the fuel has a coating of ash.
- This barbecue will become very hot, do not move it during operation.
- Do not use indoors.
INSTALLATION
- Pic. 1: Please check if all parts are included.
- Pic.2: Mount the grease tray holder under the base.
- Pic. 3: Mount the feet to the bottom of the base.
- Pic.4: Place the filter into the base and the grease tray in the designated holder.
- Pic.5: Slide the pulley over the tube and mount it with the designated screw now you can place the tube into the already fixed holder on the base.
- Pic.6: If the barbecue is completely installed you can hook on the grill rack
CLEANING AND MAINTENANCE
- Never use abrasive cleaners, metal brushes or paint thinner to clean the base, otherwise the barbecue will be damaged.
- The grill rack can be cleaned with a metal brush and abrasive cleaners, please make sure the rack will be rinsed and dried after cleaning. After cleaning apply a thin layer of cooking oil to the rack.
- Note that the surface of the barbecue will change its color as a result of being heated.
FCC Warranty
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
