CONAIR GS7 Compact Upright Fabric Steamer User Manual
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
DANGER
Any appliance is electrically live even when the switch is off. To reduce the risk of death by electric shock:
- Always unplug the appliance immediately after use and before cleaning.
- Do not place or store appliances where they can fall or be pulled into a tub or sink.
- Do not place in, or drop into water or other liquid.
- Do not reach for an appliance that has fallen into the water. Unplug immediately.
- Use only in a dry area.
WARNING
To reduce the risk of burns, electrocution, fire, or injury to persons:
- This appliance should never be left unattended when plugged in.
- This appliance is not a toy and should not be used by children.
- Close supervision is necessary when this appliance is used near children or individuals with certain disabilities. Unsupervised use could result in fire or personal injury.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Conair.
- Always position the iron carefully to prevent it from falling if the ironing board is accidentally moved or the cord is pulled. Always rest the appliance upright on its heel rest, on a stable surface, when not in use.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged, or dropped into water. Do not attempt to repair the appliance. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used. Return the appliance to an authorized service center for examination and repair.
FOR HOUSEHOLD USE ONLY
UNPACKING INSTRUCTIONS
Place the box on a large, sturdy flat surface. Carefully remove the appliance from the packing material. Keep all plastic bags away from children.
STEAMER ASSEMBLY STEP
Assembling the Support Rod 1. The telescopic support rod comes in one part: 1 collapsed pole (with plastic connectors on it) with one T-nozzle cradle.
Insert the larger metal bottom of the pole into the holder on the unit base (Fig. a). Twist the metal screw on the back of the unit base until it is tight.
Open the plastic connectors and extend the telescopic pole. Close the plastic connectors so the pole locks in place (Fig. b). Slide the T-nozzle cradle onto a pole (Fig. c).
STEP 2
Attaching the Steamer Hose Insert the hose cap into the steamer housing and twist clockwise to securely lock the hose onto the housing.
Connecting the Lint and Bristle Brush Attachments (if the model comes with accessories)
Removing the Steamer Hose
(make sure the unit has cooled) To remove, turn counterclockwise to release. Turn slowly.
- One quarter turn.
- Continue to turn until the hose is released.
OPERATING INSTRUCTIONS
BEFORE FILLING THE WATER TANK
Turn the water tank upside down and inspect to make sure the valve and spring assembly are functioning. Place the tank in the reservoir and check that it is seated securely. If the tank has been stored with water inside, it may be necessary to remove the water and clean the tank. Follow the steps for care and cleaning.
FILLING THE WATER TANK (PRIOR TO PLUGGING IN THE APPLIANCE)
turn upside down. Unscrew the valve cap in the center of the base. Fill the tank by holding the tank under a source of running cold water until the tank is filled to the desired level. Do not overfill. Screw the valve cap onto the water tank and return the tank to the upright position. Place the water tank onto the base and make certain it is seated properly in the cavity. DO NOT FILL THE TANK WITH HOT WATER.
ETTING TO KNOW YOUR STEAMER
OPERATING THE STEAMER
- Make sure the ON/OFF switch is in the OF position.
- Make sure all hose connections are secure and tight.
- Make sure the rod is fully assembled and the hose is not twisted or kinked.
- Plug the steamer cord into a normal electrical outlet.
- Turn the ON/OFF switch to the ON position.
- The switch will light to indicate when power is on.
- Steam will be produced from the nozzle in about one minute.
CAUTION:
The hose will be hot when in use. Avoid prolonged contact.
CLEANING AND STORING
- Turn the ON/OFF switch to the OFF position and unplug from the power source.
- Wait for the steamer to cool completely (at least 30 minutes).
- Unplug the power cord and gently wrap it around the built-in cord wrap.
- Remove the steamer hose.
- Remove the water tank from the unit, unscrew the valve cap, and empty unused contents. Allow to air dry.
- Remove excess water from the reservoir by lifting the unit and pouring it into a sink.
- Replace the water tank.
- Store the unit.
DECALCIFICATION
If the appliance begins to produce steam more slowly than usual, if the steamer stops producing steam and then starts again, or if the low-water indicator lamp illuminates even with the water tank full, you may need to decalcify your steamer. Decalcification refers to removing the calcium deposits that form over time on the metal parts of the steamer. For the best performance from your Conair® Fabric Steamer, decalcify the unit from time to time. The frequency depends upon the hardness of your tap water and how often you use the steamer.
To decalcify, use a solution of 1/3 white vinegar and 2/3 water in the water tank. Replace the water tank in the unit. Plug the unit into an electrical outlet. Turn to the ON position and run until half the amount has steamed (1 liter). Turn the unit to the OFF position, unplug it from the electrical outlet, and allow it to sit for 30 minutes. Remove the water tank.
HOW TO STEAM
Grasp the T-handle steam nozzle with the steam jets facing away from you. Begin at the bottom of the fabric to allow the steam to rise inside and outside, removing wrinkles. Slowly move the nozzle from the bottom to the top of the fabric. Remove the nozzle from the garment and smooth the fabric with your free hand. Some fabrics are best steamed on the underside of the material. This will allow the fibers of the fabric to relax, eliminating wrinkles.
NOTE:
Test fabric for colorfastness in an inconspicuous spot. Drape linens, towels, handkerchiefs, and napkins over a rod or place on a towel rack. Heavier fabrics may require repeated steaming. Repeat as necessary. With practice, you will gain speed and efficiency. You will soon learn which fabrics require multiple steam applications. Do not directly touch velvet or silk with the steam head.
TROUBLESHOOTING
- PROBLEM – Steamer fails to heat CAUSE – Steamer not plugged in SOLUTION – Plug into an electrical outlet.
- PROBLEM – No steam CAUSE – The water level is low SOLUTION – Turn the ON/OFF switch off and refill the water tank
- PROBLEM – Water drips from nozzle CAUSE – Condensation in hose SOLUTION – Hold the hose vertically and allow water to drain back into the unit
- PROBLEM – Nozzle gurgles CAUSE – Condensation in hose SOLUTION – Hold the hose vertically and allow water to drain back into the unit
- PROBLEM – Poor steam performance CAUSE – Sediment in tank SOLUTION – Decalcify reservoir and water tank.
Limited 1-Year Warranty (U.S. and Canada Only)
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $3.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-334-4031 for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
Service Center
- Conair Corporation
- Service Department
- 7475 N. Glen Harbor Blvd.
- Glendale, AZ 85307
REFERENCE LINK
https://www.conair.com/en/compact-upright-fabric-steamer/GS7RXF.html?lang=en_US
