Table of contents
show
DYNATRAP DT3030 Access Steam Pocket Handheld Steamer User Guide
IMPORTANT SAFETY INSTRUCTIONS
- Always furn unit off and disconnect plug before servicing, cleaning, or changing bulbs.
- Do not position the unit near heat, gas, oil or other flammable materials.
- Mount product out of reach from children
- Do no! attempt lo defeat this safety feature.
- This appliance is provided with double insulation. Use only identical replacement parts.
- Avoid prolonged eye contact with the light.
PARTS LIST
HOW IT WORKS
INSTALLATION
- Install Trap at o height of 6′-0″ to 6′-6″ from the floor, near a plug socket and away from direct sunlight
- Drill three holes with 3/16′ bit to a depth of 1-1/B”.
- Insert the screws into the wall anchors leaving 3/16′ of the screw sticking out to hang the trap an.
- Hold the fly trap on both sides and align the mounting holes with the Screw and hang the trap. Install the covering caps an the top two screw.
HOW TO USE
- Press front cover to Lock and Unlock
Lift front caver and hook support brace an support past.- Push handle of Glue Board Holder down slowly
Remove liner from Sticky Tech™ Glue Board and insert into holder by aligning edges.
Lift handle of the glue board holder upwards until you hear a “click”.
Plug in to turn on lights and begin trapping insects
Lift front caver and hook support brace an support past.
Remove liner from Sticky Tech™ Glue Board and insert into holder by aligning edges.
Lift handle of the glue board holder upwards until you hear a “click”.
Plug in to turn on lights and begin trapping insects
MAINTENANCE
- Light bulbs are recommended to be replaced every 4 months (3,000 Hours) for optimal results.
- Open the trap with soft cloth and neutral detergent. (Unplug before cleaning)
TROUBLESHOOTING
| Problem: | Possible cause: | Correction: |
| Does Not Work |
|
|
| Bulb does not illuminate |
|
|
| Flies are not being trapped |
|
|
