Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Feature-Image

Picun E5 Wireless Bluetooth Kids Headphone User Manual

Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Image

Picun E5 Wireless Bluetooth Kids Headphone User Manual

Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Image-1

Packing List

  1. Wireless Headphone
  2. Charging Cable
  3. Audio Cable
  4. User Manual

LED Indicator Light Description

Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Image-2

Basic Key Operation

Turn ON:
Long press to turn on, the blue LED will stay on for 1s and then enter the pairing state, and red and blue LED will flash alternately.

Turn OFF:
Long press the headphone will be turned off  and red LED will stay on for 2 seconds, then go out.

Volume Adjustment:
Short press to control volume.

Music Selection:
Long press to skip to the next song.

Toggle Switch to Adjust Volume:

  • Toggle the switch up to 93DB
  • Toggle the switch down to 85DB

Appearance Wireframe

Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Image-3

Parameter Information

Picun-E5-Wireless-Bluetooth-Kids-Headphone-User-Manual-Image-4

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference
  2. This device must accept any interference received, including interference that may cause undesired operation.
    Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Consult the dealer or an experienced radio/TV technician for help

Leave a Reply