Etekcity EB9380H Digital Body Weight Scale User Manual

Etekcity EB9380H Digital Body Weight Scale User Manual

Thank you for purchasing the Digital Body Weight Scale by Etekcity.
If you have any questions or concerns, please reach out to our helpful Customer Support Team at support@etekcity.com. We hope you enjoy your new scale!

Specifications

READ AND SAVE THESE INSTRUCTIONS

Safety Information
Please read and follow all instructions and safety guidelines in this manual.

General Use 

• Check the scale before using it. Do not use the scale if it is damaged in any way.
• Do not strike or bang on the scale and do not use the scale if there is a slight crack on the glass. Due to the nature of tempered glass, the glass will shatter if there is a slight crack. If you see a crack, contact Customer Support.
• The glass platform is slippery when wet. Always make sure the platform and your feet are dry before stepping onto the scale.
• Place the scale on a hard, flat surface.
• To weigh safely and accurately, stand with your feet shoulder-width apart while on the scale. Do not stand on the edge of the scale or jump on the scale.
• Avoid standing on the scale for a long period of time.
• Do not overload the scale. Maximum weight capacity is 400 lb / 180 kg / 28 st.
• Keep the scale in a cool area with low humidity. Keep the scale away from heat sources, such as ovens or heaters
• Store the scale horizontally, not vertically.
• For household use only. This scale is not intended for commercial use.
• Handle with care.

Batteries

• Do not mix new and old batteries.
• If the scale is not in use for a long period, remove the batteries to extend the lifetime of the scale.

Function Diagram

• A. Display
• B. Platform
• C. Anti-Skid Padding
• D. Battery Compartment
• E. Unit Conversion Button

Before First Use

1. Open the battery compartment on the underside of the scale. Remove the included AAA batteries.
2. Remove the plastic strip.
3. Replace the batteries. Follow the guidelines in the battery compartment to match the + and – terminals.

Operation

Using the Scale

1. Place the scale on a hard, flat surface.
   Note: Using the scale on soft surfaces such as carpets and mats will result in inaccurate measurements.
2. Step on the scale, then step off. Wait for the screen to display  before using.
3. Stand on the scale until the display flashes several times, showing your final measurement.

Switching Units

1. Press the unit conversion button on the underside of the scale to switch units between pounds (lb), kilograms (kg), and stone (st).
2. The default unit is pounds (lb). After changing units, the scale will show the new unit of measurement.

Clearing the Scale
If the scale has been moved or flipped upside down, it must be cleared to ensure accurate results.

1. Place the scale on a hard, flat surface.
2. Step on the scale until digits appear on the display, then step off.
3. The scale will show “ ” when cleared.

Replacing the Batteries

1. Open the battery compartment on the underside of the scale.
2. Remove the old batteries and dispose of them properly.
3. Install 3 new 1.5V AAA batteries. Make sure the polarities match.
4. Close the battery compartment, place the scale on a hard, flat surface, and wait for the display to show before using it.

Cleaning the Scale

1. Use a slightly damp cloth to clean the surface of the scale, followed by a soft, dry cloth to wipe away the remaining moisture.
2. Do not use chemical or abrasive cleaning agents to clean the scale.

Troubleshooting

Federal Communication Commission Interference Statement – Part 15

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

Warranty Information

TERMS & POLICY
Etekcity Corporation (“Etekcity”) warrants this product to the original purchaser to be free from defects in material and workmanship, under normal use and conditions, for 2 years from the date of original purchase. Etekcity agrees, at our option during the warranty period, to repair any defect in material or workmanship or furnish an equal product in exchange without charge, subject to verification of the defect or malfunction and proof of the date of purchase.

There is no other express warranty. This warranty does not apply:

• If the product has been modified from its original condition;
• If the product has not been used following directions and instructions in the user manual;
• To damages or defects caused by accident, abuse, misuse, or improper or inadequate maintenance;
• To damages or defects caused by service or repair of the product performed by an unauthorized service provider or by anyone other than Etekcity;
• To damages or defects occurring during commercial use, rental use, or any use for which the product is not intended;
• To damages or defects exceeding the cost of the product.

Etekcity will not be liable for indirect, incidental, or consequential damages in connection with the use of the product covered by this warranty. This warranty extends only to the original consumer purchaser of the product and is not transferable to any subsequent owner of the product regardless of whether the product is transferred during the specified term of the warranty. This warranty does not extend to products purchased from unauthorized sellers.

Etekcity’s warranty extends only to products purchased from authorized sellers that are subject to Etekcity’s quality controls and have agreed to follow its quality controls. All implied warranties are limited to the period of this limited warranty. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

If you discover that your product is defective within the specified warranty period, please contact Customer Support via support@etekcity.com. DO NOT dispose of your product before contacting us. Once our Customer Support Team has approved your request, please return the product with a copy of the invoice and order ID. Every Etekcity product automatically includes a 2-year warranty. To make the customer support process quick and easy, register your product online at www.etekcity.com/warranty.

This warranty is made by:

• Etekcity Corporation
• 1202 N. Miller St., Suite A
• Anaheim, CA 92806

Support

If you encounter any issues or have any questions regarding your new product, please contact our helpful Customer Support Team.

• Etekcity Corporation
• 1202 N. Miller St., Suite A
• Anaheim, CA 92806
• Toll-Free: (855) 686-3835
• Email: support@etekcity.com
• Support Hours
• Mon–Fri, 9:00 am–5:00 pm PST/PDT

*Please have your order invoice and order ID ready before contacting Customer Support.

REFERENCE LINK