SoundPeats Engine 4 Powerful High-Fidelity Wireless Earbuds User Manual
First Time of Use
- Please open the lid of the charging case to take out the headphones, remove the insulating film from the top of both headphones, then put both headphones back into the charging case. Press and hold the button at the bottom of the charging case for 3 seconds until the indicator light inside the charging case flashes white. They are in pairing mode then.
- Turn on our device’s Bluetooth and select SOUNDPEATS Engine 4 from the Bluetooth list to complete the pairing.
Pairing of a Second Device
SOUNDPEATS Engine 4 earphones can be paired simultaneously with two devices, How to connect: Once the earphones are paired with device A, turn off the Bluetooth of device A. Repeat the pairing operation to connect the earphones to device B. When the pairing is completed, please turn on the Bluetooth of device A to complete the pairing.
Reset
- Place both earphones back into the charging case, and make sure they are correctly placed.
- With the case lid open, press and hold the button on the bottom of the charging case for 10S until the indicator light inside the charging case flashes white twice.
- Close the case lid and open it again, and the earphones are activated successfully.
Wearing methods
- Identify the left and right earphones.
- Adjust the earphones to fit your ears.
Product Diagram
Controls
Q&A
Q1: What does the indicator light of the charging case display?
- The battery life of the charging case ( When the charging case not in charging mode):
- Charging status of the charging case:
Q2:What does the indicator light on the bottom of the charging case display?
It shows the charging status of the charging case. There are two states of the indicator light while the user is charging the charging case:
- The red indicator light is always on when the charging case is not fully charged.
- The red light goes out when the charging case is fully charged.
Q3: How to charge the charging case?
- Connect the charging case to a Type-C charger. (The current does not exceed IA).
- If the earphones stay idle for an extended period, charge them at least every three months to prevent the battery from being damaged.
Q4: Why are the earphones still connected to the phone when they are put back to the charging case and the case lid is closed?
- Check whether the charging case has battery power. If it has run out of battery, closing it will not disconnect the earphones from the device.
- Ensure the earphones are properly placed in the charging case and the charging metal sheet and PIN are clean. And wiping clean the contact points on the earphones and the charging case should fix this issue.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired
Changes or medications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
DOWNLOAD PDF LINK
