UBIQUITI ETH-SP Ethernet Surge Protector Manual
Hardware Overview
ETH IN/OUT Passive, surge-protected RJ45 Ethernet ports.
Grounding Point The ETH-SP must be grounded by one of the following methods:
- Using the included Self-Tapping Screw to ground the ETH-SP directly to a grounded metal pole or structure; or
- Using an M5 machine screw and nut (not included) to attach a drain wire that is connected to a remote grounding block or structure.
Package Contents
- ETH-SP
- M5 Self-Tapping Screw
- M5 Serrated Washer
Connect a Drain Wire (Optional)
If a drain wire is used to properly ground the ETH-SP, attach it to the Grounding Point with an M5 machine screw and nut (not included).
Note: Place the included Serrated Washer between the screw and drain wire.
Installation
Install the ETH-SP near an Ethernet device, either on a pole or a wall. Follow the appropriate steps for your installation:
Pole-Mounting
- Thread a metal strap or cable tie (not included) through the slot located on the back of the ETH-SP.
Note: If the Ethernet device is mounted on the pole with a metal strap, you may use the same strap to attach the ETH-SP. - Wrap the strap or tie around the pole and secure it to the pole.
- Remove the port cover by pressing on the center and sliding the cover downward.
Note: If you are using a drain wire for grounding, proceed to the last section, Connecting Ethernet. - Drill a 4.5 mm pilot hole into the pole through the center of the Grounding Point of the ETH-SP.
- Insert the included Self-Tapping Screw into the Serrated Washer and pilot hole. Securely fasten the screw to ensure the Grounding Point is bonded
to the pole.
Connecting Ethernet
Connect two Ethernet cables to the RJ45 ETH IN/OUT ports. Then connect one of the cables to the Ethernet device and the other cable to the LAN.
Specifications
Safety Notices
- Read, follow, and keep instructions.
- Heed all warnings.
- Only use attachments/accessories specified by the manufacturer.
Electrical Safety Information
- Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed.
- There are no operator-serviceable parts inside this equipment. Service should be provided only by a qualified service technician.
- The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.
- Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment.
- Protective bonding must be installed in accordance with local national wiring rules and regulations.]
Returns
No Products will be accepted for replacement or repair without obtaining a Return Materials Authorization (RMA) number from UBIQUITI NETWORKS during the warranty period, and the Products being received at UBIQUITI NETWORKS’ facility freight prepaid in accordance with the RMA process of UBIQUITI NETWORKS. Products returned without an RMA number will not be processed and will be returned to freight collection or subject to disposal. Information on the RMA process and obtaining an RMA number can be found at: www.ubnt.com/support/warranty
Compliance
Note
Some countries, states, and provinces do not allow exclusions of implied warranties or conditions, so the above exclusion may not apply to you. You may have other rights that vary from country to country, state to state, or province to province. Some countries, states, and provinces do not allow the exclusion or limitation of liability for incidental or consequential damages, so the above limitation may not apply to you.
EXCEPT TO THE EXTENT ALLOWED BY LOCAL LAW, THESE WARRANTY TERMS DO NOT EXCLUDE, RESTRICT OR MODIFY, AND ARE IN ADDITION TO, THE MANDATORY STATUTORY RIGHTS APPLICABLE TO THE LICENSE OF ANY SOFTWARE (EMBEDDED IN THE PRODUCT) TO YOU. The United Nations Convention on Contracts for the International Sale of Goods shall not apply to any transactions regarding the sale of the Products.
FCC
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. This device complies with part 15 of the FCC Rules.
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
RoHS/WEEE Compliance Statement
European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product.
018-2019 Ubiquiti Inc. All rights reserved. Ubiquiti, the Ubiquiti U logo, the Ubiquiti beam logo, UniFi, and UniFi Protect are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries. Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc, registered in the U.S. and other countries. Android, Google, Google Play, the Google Play logo, and other marks are trademarks of Google, LLC. All other trademarks are the property of their respective owners.