Oster FPSTHBEKFC-AL Food Prep Kit with Blender User Manual

Oster FPSTHBEKFC-AL Food Prep Kit with Blender User Manual

IMPORTANT SAFEGUARDS

1. To protect against electric shock, do not place or immerse cords, plugs, or appliances in water or other liquid.
2. This appliance is not intended for use by children or by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge. Avoid contacting moving parts.
3. The flashing light indicates ready to operate (models with standby mode). Avoid any contact with blades or moveable parts.
4. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Do not attempt to replace or splice a damaged cord. Return the appliance to the manufacturer (see warranty) for examination, repair, or adjustment.
   

   Continued

5. For appliances with markings on the plug blade: This appliance has important markings on the plug blade. The attachment plug or entire cord set (if the plug is molded onto the cord) is not suitable for replacement. If damaged, the appliance shall be replaced.
6. The use of attachments, including canning jars, not recommended or sold by the manufacturer may cause fire, electric shock, or injury.
7. Do not use it outdoors or for commercial purposes.
8. Do not let the cord hang over the edge of the table or counter, or touch hot surfaces, including the stove.
9. To protect against fire, do not operate the appliance in the presence of explosive and/or flammable fumes.
10. Do not place appliance on or near a hot burner or in a heated oven.
11. Do not use over a stove or other heat source.
12. Add ice to the beverage after mixing.

PLUG INSTRUCTIONS
POLARIZED PLUG

If the plug does not fit fully into the outlet, reverse the plug. Do not attempt to modify the plug in any way. If the plug fits loosely into the AC outlet or if the AC outlet feels warm do not use that outlet.

DESCRIPTION OF THE APPLIANCE

1. Motor Housing
2. On/Off Button
3. Hanging Loop
4. Stainless Steel Beater Shaft
5. Chopping Bowl
6. Chopping Blade
7. Chopping Bowl Cover
8. Electric Knife
   1. a Stainless Steel Blades
   2. b.Eject Button
   3. c., d. On/Off Electric Knife Buttons

USING THE CHOPPER

The chopper is ideal for chopping a wide range of vegetables, dried fruits, nuts, etc.

• Insert the chopping blade into the chopping bowl.
• For best results, cut large ingredients into pieces of approximately 12.7 mm (1/2 inch) cubed before chopping. CAUTION: Do not chop large ice cubes or extremely hard foods.
• Secure the chopping bowl cover by setting on the bowl, press down, and turn to the right until firmly locked into place. The upper shaft of the chopping blade will fit into the receiving hole in the underside of the cover.
• Attach the motor housing into the top of the food chopping bowl cover and turn to the right until the motor housing is firmly locked into place. Plug cord into convenient outlet.
• Press and hold the on button to switch the unit on. Release the button to switch the unit off.
• If the ingredients stick to the sides of the chopping bowl, loosen them by adding a small amount of liquid or by using a spatula to scrape the food back into the inner part of the bowl.
• Release the on button and allow the blade to come to a complete stop before removing the bowl cover by turning cover to the left. Take care when removing the blade and hold only by the shaft handle as the metal blade is sharp.

USING YOUR ELECTRIC KNIFE

• Be sure the electric cord is not connected to the outlet when attaching the electric knife or inserting/ removing the knife blades.
• Pick up the knife blades inside the protective cover, holding it between the thumb and forefinger. Avoid touching the sharp, scalloped edges of the blades.
  
• Insert the raised rivet on one blade into the keyhole slot on the other blade. This locks the ends of the blades. Holding the blades with the drip guards between the thumb and forefinger, and with the scalloped edges of the blades facing away from the hand, slide the ends of the blades into the opening on the front of the power handle.
• Plug the electrical cord into an electrical outlet. Use only voltage specified on bottom of the unit.
• Press the on/off buttons located on top and bottom of the handle to activate the knife and begin carving.

MAINTENANCE AND CLEANING

• The motor housing should be wiped clean with a damp cloth or sponge.
  CAUTION: NEVER immerse the motor unit in water.
• After using the unit, the beater shaft, mixing cup, chopping bowl, chopping blade, and electric knife blades may be washed by hand with mild soap and water. Wash food chopping bowl cover by hand using warm, soapy water with a cloth or sponge.

3-Year Limited Warranty

Sunbeam Products, Inc. (collectively “Sunbeam”) warrants that for a period of three years from the date of purchase, this product will be free from defects in material and workmanship. Replacement will be made with a new or remanufactured product or component.

If the product is no longer available, a replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. This warranty is valid for the original retail purchaser from the date of the initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. Sunbeam dealers, service centers, or retail stores selling Sunbeam products do not have the right to alter, modify, or in any way change the terms and conditions of this warranty.

REFERENCE LINK

https://www.oster.com/food-preparation/electric-knives/food-prep-kit-with-immersion-blender-electric-knife-and-mini-chopper/SP_1386570.html