Dr. Infrared Heater GFI-2403-01 Electric Fireplace Freestanding Heater User Guide
IMPORTANT SAFETY INSTRUCTIONS
- Do not operate any heater after it malfunctions. Disconnect power at service panel and have heater inspected by a reputable electrician before reusing.
- To disconnect heater, turn controls to off, and turn off power to heater circuit at main disconnect panel.
- Extreme caution is necessary when any heater is used by or near children.
- Always unplug this appliance when not in use.
- Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or damaged in any manner.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Do not use outdoors.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.
- To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
PACKAGE CONTENTS
- Fireplace x 1
- Remote Control x 1
- Battery x 2
- Leg x 4
- Screws (M4 x 12 mm) x 12
- User Manual x 1
LEG ASSEMBLE
PRODUCT OVERVIEW
CAUTION: High temperature, keep electrical cords, drapery, and other furnishings at least 3 feet (0.9 m) from the front of the heater and away from the side and rear.
Plug into an appropriate voltage AC 120V outlet, The unit will enter standby mode with display screen on red. Your heater is ready for use now.The flame effect feature is majority red visible from a point 10 feet (3 m) in front of the center of the heater and 5 feet (1.5 m) above the floor, and it is energized whenever the on-off switch is in the on position.
- Heating area
- Front cover and Realistic flame and logs glowing
- Control panel
- Leg
- Door handle
- Temperature display
- Timer
- Flame level
- Temperature
- Power on/off
REMOTE CONTROL
BATTERY REPLACEMENT
- Replace with two 1.5V AAA batteries
- Do not mix old and new batteries.
- Do not mix alkaline, standard(carbon zinc), or rechargeable(nicad, ni-mh,etc.) batteries
PRODUCT SIZE
OPERATION
By Buttons on Control Panel
- Press the button to power on or off the unit.
- Press and hold about 10 seconds during powering on to lock the unit, the front flame effect display will flash. Hold again for about 10 seconds to unlock.
- Press the button repeatedly to switch to desired temperature from 17 to 27 (62 to 82 ).
- Press and hold the button about 3 seconds to switch between and . F C
- Press the button repeatedly to switch to F5 to F1 or set off flame level.
- Press the button repeatedly to set the timer to 30 minutes, 1H to 9H or 00 (off).
By Remote Control:
- Press the button to power on or off the unit.
- Press the button repeatedly to switch to F5 to F1 or set off flame level.
- Press the button repeatedly to switch to desired temperature from 17 to 27 (62 to 82 ). F
- Press the button repeatedly to set the timer to 30 minutes, 1H to 9H or 00 (off).
- Press the button repeatedly to set the flame speed to S1-S5.
MAINTENANCE
- The motors for the fan and the flame generator assembly are pre-lubricated for extended bearing life and require no further lubrication. However, we recommend periodic cleaning/vacuuming the fan/heater.
- Clean the trim using a soft cloth, slightly dampened with citrus oil based product and buff with a clean soft cloth.
- Make sure the unit is turned OFF and unplugged before cleaning the heater or fireplace. with a clean soft cloth.
DO NOT use brass polish or household cleaners as these will damage the metal trim. Citrus oil based products can be obtained at supermarkets or hardware stores. - Do not allow water to run into the interior of the heater as this could result in a fire or electric shock hazard.
- Any other servicing should be performed by an authorized service representative.
- Except cleaning, any other servicing should be performed by an authorized service representative.
- Carefully fold the power supply cord and tie it up with a cord, then put the heater into the packing box. Keep it in a location away from any hot or wet location.
SPECIFICATION
- Power: 120V~,60Hz
Rated Wattage: 1500W(+5%-10%) - Remote working range: up to 26.2 feet
TROUBLESHOOTING
1 Year Limited Warranty
The product is warranted against defects in materials and workmanship under normal use and service for a period of one year from the date of original purchase when delivered to you in new condition in its original container, warranty repair or replacement shall not extend the original warranty period of the product, a dated proof of purchase is required at the time of warranty service, a copy of your dated bill of sale will satisfy this requirement. This warranty does not cover accessories or consumables, such as light bulbs, as to which there shall be no warranty or replacement.
