Table of contents
show
PULSAR Go Series Thick Oil Vape User Guide
KIT CONTENTS
- Thick Oil Vape Unit Mouthpiece
- 1 x Glass Housed 0.8ml Ceramic Cartridge
- Micro USB Charging Cable
CHARGING INSTRUCTIONS
You will need to fully charge your Pulsar® Go Series Thick Oil Vape before using it. Insert charging cable into unit & the other end into a dedicated USB port or wall socket if using AC wall adapter (Not Included). Set Pulsar® Go Series Thick Oil Vape on its side – do not let unit dangle from charge cord. This puts pressure on the charger plug that can result in the unit not charging fully.
- Battery Charge time: Allow approximately 2 hours for the first full charge. Do not charge for more than 24 hours.
- Battery Charging: Battery indication light will show charging connection is made by pulsing Red. When fully charged, light turns to Green. The Pulsar® Go Series Thick Oil Vape battery will deliver approximately 2 hours of continuous power, depending on use. Both the battery and chargers are designed to prevent overcharging. ONLY USE APPROVED PULSAR® CHARGERS! Failure to do so can damage the battery, which can result in property damage or personal injury and may void the warranty.
Using the Pulsar® Go Series Thick Oil Vape
- Start by gently pressing the mouthpiece on the taller side, and SLIGHTLY popping it loose from the housing.
- Glass cartridge may be snuggly fit inside the mouthpiece as you pop it off. Simply pull the two apart.
To fill the cartridge, unscrew the top, and set to the side.Fill inner glass chamber with liquid.- Simply drop the filled cartridge back into the unit and the magnetic connection.
To fill the cartridge, unscrew the top, and set to the side.Fill inner glass chamber with liquid.
TECH SPECS:
- Input: 5V/400mAh
- Battery Capacity: 650mAh
- Atomizer Coil Resistance: 0.2Q Leak Proof 0.8ml Ceramic Coil
Battery Indicator
- Red Light: Low Battery
- Yellow Light: Middle Level
- Green Light: Nice Solid Charge
- Micro USB Charging Port
