ATRIX GSBUN10 Wireless Speaker User Manual
Overview
Speaker LED Indicators
- Rapid Flashing Blue – Pairing
- Solid Blue – Paired
- Solid Red – Charging
- No Red light – Charging complete
Pairing the Speaker
Pairing
- Power ON the speaker.
When pairing for the first time the speaker will automatically enter pairing mode. The indicator light will flash blue when it is ready to pair. Use the Bluetooth settings on your device to pair with the ATRIX Cat Speaker. - The speaker is connected when the indicator light continuously flashes blue. You will hear the confirmation sound.
- The speaker will automatically reconnect to the device it was most recently paired to when you turn the speaker on and it is in Bluetooth mode.
Re-enter Pairing:
- To re-enter pairing mode disconnect from your device using the Bluetooth menu.
- Press and hold the “+” and the “” button to manually disconnect from the current device.
Charging the Speaker
- Plug the micro-USB end of the charging cable into the speaker.
- Plug the USB-A end of the charging cable into a UL-compliant power supply of at least DC 5V 500mA.
- A full charge requires approximately 2 hours.
- The Bed light will turn off when charging is complete.
Important Safety Instructions
WARNING
When using this product, basic precautions should always be followed, including the following: Read these instructions carefully.
All caution and warnings should be followed. Protect equipment from humidity. Do not use chemical detergents to clean your device, use a soft dry cloth. To avoid damage from electrical peaks unplug the device when it is not in use. If one of the following situations arises, the equipment has to be checked by qualified service personnel:
- Liquid has penetrated into the equipment.
- Equipment has been exposed to humidity.
- Equipment has been dropped and/or is damaged.
- The equipment has obvious signs of breakage.
- Equipment does not work well or you cannot get it working according to the user’s manual.
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
