Table of contents
show
Honeywell T6 Smart Thermostat User Manual
INSTALLATION GUIDE
Turn OFF the power and remove the old thermostat
To ensure your safety, always make sure mains power is switched OFF before accessing wiring. Before removing the old thermostat take a picture of the old thermostat’s wiring as reference then proceed to installation. It should be at least 1.2 – 1.5 meters from the floor.
Prepare Receiver Box for installation
Before installation of the Receiver Box Find a suitable location near to the boiler. Needed during installation:
- Cable with 2 wires from the Receiver Box (R4H810A) to thermostat.
- Cable with 2 wires from the boiler to Receiver Box.
- The Receiver Box requires 230V power
Install the Receiver Box
- Wall box or Rear Wiring: Hinge open the terminal block flap to access the cables and wall box screw holes.
Surface wiring: Use the cable clamps to secure the surface wiring.
Replace the cover: Locate the hinges at the top of the cover and wall plate, close the cover and secure with the screw.
Surface wiring: Use the cable clamps to secure the surface wiring.
Replace the cover: Locate the hinges at the top of the cover and wall plate, close the cover and secure with the screw.
- Using a screwdriver open wall plate terminal cover to connect wires
Connect 2 thermostat wires to the T and T terminals and close cover.
Connect 2 thermostat wires to the T and T terminals and close cover.
Complete installation
- Turn ON mains power to the Heating Appliance and Receiver Box.
- After power up, SETUP is displayed on the thermostat’s screen.
Setup Instruction
- Touch to begin setting up the thermostat.
- Select your language.
- Set the clock format, time and date.
- Touch to finalise setup.
Wiring Diagrams
- Basic 230V boiler
Combi boiler
Open Therm boiler
Two-port zone valve or S-plan
Combi boiler
Open Therm boiler
Two-port zone valve or S-plan
FAQS
How do I use my Honeywell T6 thermostat?
- To turn the system off press the mode. Button until the word off appears on the screen. This concludes the general use tutorial for the Honeywell T6.
How does the Honeywell smart thermostat work?
- Thermostat automatically adapts to your schedule and learns preferred heating and cooling cycle times to fit your lifestyle
Are Honeywell thermostats battery operated?
- Honeywell thermostats typically use AA or AAA alkaline batteries.
Is the Honeywell thermostat Wi-Fi?
- This smart thermostat also connects to your existing Wi-Fi to give you control from your smart device via the Total Connect Comfort app.
Can I control my Honeywell thermostat from my phone?
- Just link your thermostat to a Honeywell Home remote gateway and you can control your home heating with our Total Connect Comfort app or login via browser.
How to check thermostat battery?
- Take those out make sure you put them in in the right. Direction. And and line up these four pegs on the back side of these four holes. And just snap it back into. Place.
How do I open a thermostat cover?
- Put it in the slot. And as I push up on the screwdriver. I’m going to pull out towards me from the bottom of the face plate here we go. So I’m going to push. Up. Pull out.
What is a staging thermostat?
- Staging allows your furnace or air conditioner to use only the output it needs to heat or cool your home.
What are the advantages of a smart thermostat?
- Its ability to reduce energy consumption by optimizing heating and cooling.
