Table of contents
show
Hover X1 Pocket Sized Self Flying Camera User Manual
Product Overview
- Power & Takeoff Button
- Mode Button
- Status Indicator
- Battery
- Battery Level Indicator
- Cimbal Camera
- Status Indicator
- Motor
- Propeller
- Heat Vents
- Downward Vision System
- Prop Guard
Get Started
Step 1 Download App
Scan the QR code below to download and install Hover X1 App. *This guide is subject to change without prior notice. Please visit our official website for user manual and other latest information.
Step 2 Charge the battery
- before you use Hover Camera XI for the first time, be sure to charge it
Step 3 Power on
- Press and hold power button for 2 seconds until the voice prompt is heard, and the status indicator will light on in green.
Step 4 Mode selection and fly
- Spread Hover Camera X1 as shown below. You can switch modes using the mode button. Hold Hover Camera X1 horizontally. Press the power button.
- All propellers will start spinning. Release Hover Camera X1 and it will perform the flight.
- Take off
Step 5 Collect Hover Camera X1
- Pick up Hover Camera Xl in flight and press the power button or flip it by 180°, and the propellers will stop spinning.
- Put your hand 20 cm below Hover Camera X1, and it will automatically land on your hand and stop propeller soinnina.
Caution
DO NOT stick any finger or anything else into the propeller area. Please refer to the safety instruction manual and disclaimer on zzrobotics.com/support for more information.
Step 6 App connection
- Open the Hover X1 App and enjoy flying Hover Camera X1.
REFRENCE LINK