Hugolog HU02 Digital Smart Locks User Manual

Hugolog HU02 Digital Smart Locks User Manual

Warnings

• Failure to follow these instructions could result in damage to the product and avoid the factory warranty
• The accuracy of the door preparation is critical for the proper functioning and security of this product. Misalignment can cause performance degradation and lessening of security.
• Finish Care: This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure a long-lasting finish. When cleaning is required use a soft, damp cloth. Using lacquer thinner, caustic soaps, abrasive cleaners, or polishes could damage the coating and result in taming.

IMPORTANT:
Do not install batteries until the lock is completely installed on the door.

1. Master PIN Code (4~10 digits): The default master PIN code is “12345678”,, please modify it after installation. If you forget your master PIN code, you can reset your lock back to factory settings.
2. User PIN Code (4~10 digits): User PIN codes can be set up through the master PIN code. Up to 20 user PIN codes can be stored.
3. Both master and user pin codes don’t support the following combination of numbers.

Parts Illustrations

CAUTION
Master and user PIN codes have 4-10 digits, the default master PIN code is [ 12345678 ]. Please change it before programming the lock.

Definitions

Master Mode The master mode can be entered by entering| **+Master PIN Code+# ] to program the lock. Master PIN Code: The master PIN code is used for programming and feature settings. Passing Mode: The lock could be adjusted to the passing mode by the handle switch. In this mode, a pin code and key are not needed to unlock the door. Passing mode will be disabled after long-pressing any buttons for 2 seconds from outside and will be resumed when the door is unlocked again by PIN code or a key.

Fake Pin Code: It is the random number that is added before or after the user password. This prevents the user password from being exposed. Shutdown Time: The lock will shut down for a default of 3 minutes and not allow operation after the wrong code entry limit (10 times) has been met. When the unit is shut down, the light will flash when you are trying to use the keypad. Silent Mode: The beeper will not make any voice. Socas in on exterior assembly. User PIN code: The user PIN code operates the lock. The maximum number of user PIN codes is 20. Reset button: After the reset operation, the lock will be restored to factory default settings, and all user credentials will be deleted Refer to the reset guide

Factory Default settings

Lock Operation

Notes:

1. Beeps sound only when the beeper is enabled.
2. If the indicators show 3 red lights + 3 beeps, your setting fails. The system will exit master mode. Please try to enter master mode again if you continue your processing.

How to use

Normal mode 

1. Enter the master or user pin code into the keypad, then rotate the lever to open the door. The door will automatically re-lock 7 seconds later.
   
2. Insert the backup key and rotate it to 140, then rotate the lever to open the door. The door will automatically re-lock 7 seconds later.

Passing mode

1. Rotate the lever directly to open the door.
   
2. Press any key on the keypad for 2 seconds to lock the door.

Unlock with Fake PIN code

Users can prevent pin code exposure from strangers by entering random digits before or after the pin code.

Reset to factory default settings
Operations on lock

1. Open battery box and find the reset button.
2. The user a sharp thing to press and hold the reset button.
3. Keep holding the reset button and remove a battery from the battery box then replace it.
4. Keep holding the reset button for another 3 seconds until you hear the voice guide.

REFERENCE LINK