You are currently viewing Insignia NS-WC29SS9 Wine Cooler Setup Guide

Insignia NS-WC29SS9 Wine Cooler Setup Guide

Insignia-logo

Insignia NS-WC29SS9 Wine Cooler Setup Guide

Insignia-NS-WC29SS9-Wine-Cooler-Image-2

 

IMPORTANT SAFETY INSTRUCTIONS

  1. Read these instructions.
  2. Keep these instructions.
  3.  Heed all warnings.
  4. Follow all instructions.
  5. Do not use this appliance near water.

Grounding requirement

This cooler must be grounded. This cooler is equipped with a cord that has a grounding wire and plug. The
plug must be inserted into an outlet that is properly installed and grounded.Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood or if doubt exists as to whether the cooler is properly grounded.

FEATURES
  • 29-bottle capacity
  • Temperature range from 41-65° F (5-18° C)
  • Touch controls and LED display
  • Interior white LED light
  • Reversible door
  • Removable shelves

Control panel/display

Insignia-NS-WC29SS9-Wine-Cooler-Image-1

SETTING UP YOUR COOLER

Before using your cooler

  • Remove the exterior and interior packaging.
  • Let the cooler stand upright for approximately half an hour before plugging it in to reduce the possibility of a cooling system malfunction.
  •  Clean the interior with a damp, warm cloth.

Find a suitable location

DO

  • Place your cooler on a floor, countertop, or cabinet that is strong enough to support it when it is fully loaded.
  •  Allow 1.6 inches (4 cm) of space on all sides of the cooler to allow for proper air ventilation.
  •  Place the cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Room temperature below 50° F (10° C) or above 85° F (30° C) will hinder the performance.

DON’T

  •  Recess or build it in to a countertop or wall. This cooler is designed to be free standing only.
  •  Place the cooler in moist areas.
  •  Use the cooler in a garage or any other outside location.

Level your cooler

  • If the cooler is not level, the door may not close or seal properly. This may cause cooling, frost, or moisture problems.
  • To level your cooler, raise or lower the leveling feet by turning them clockwise or counter-clockwise.

Connect to power

  •  Plug your cooler in and run it for two to three hours before adding beverages and making temperature adjustments. This allows your cooler to reach a stable temperature.

Note: Check your local power source. This cooler requires a 110V-120V, 60 Hz power supply.Use a 3-prong (grounding) outlet. The power cord is equipped with a 3-prong (grounding) plug which plugs into a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this cooler.

USING YOUR COOLER

Setting the temperature

  • Press the temperature up  or down buttons to increase or decrease the temperature by one degree. The temperature range is 41-65° F (5-18° C).
  • Press and hold the temperature up and down  buttons at the same time to switch between Fahrenheit and Celsius.

Note: If you experience a power outage, your cooler will resume cooling at the temperature it was set to before the outage when it is turned on again.
Using the display

  • When you plug in your cooler for the first time, the display screen turns on for three seconds,and you hear a start-up beep.
  •  When you lock your cooler, the display turns on when a button is pressed. It turns off after 30 seconds if no buttons are pressed.
  • In normal mode, the display shows the set temperature.

Lighting your cooler

  • Press the light ( ) button to turn the light on or off. A beep sounds when the light is turned on or off.
    Locking and unlocking your wine cooler
    • Press and hold the lock ( ) button for three seconds to lock or unlock the control panel.
    Reversing the door
    • See the online user guide for steps on reversing the door.

CLEANING YOUR COOLER

  1. Turn off your cooler and unplug it from the wall outlet.
  2. Remove all beverages.
  3. Wash the interior with a damp, warm cloth.
    Note: It is recommended that you soak your cloth in a baking soda solution before washing the interior.
    Mix one quart of warm water and two tablespoons of baking soda.
  4. Clean the door gasket (seal) so the door closes properly.
  5. Dry the interior and exterior with a soft cloth.

TIPS ON SAVING ENERGY

  • Place your cooler in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.
  • Do not overload the cooler, because it forces the compressor to run longer.
  • Do not open the door too often, especially if the weather is very hot. Close the door as soon as possible to prevent cool air from escaping.
  • Make sure that the door seals completely to keep your cooler running efficiently.
  • Make sure to keep the door gasket (seal) clean to keep your cooler running efficiently.
  • Make sure that your cooler is sufficiently ventilated and is in a room with adequate air circulation.

SPECIFICATIONS

  • Dimensions (H×W×D): 33.1 × 18.9 × 17.3 in. (84.2 × 48.0 × 44.0 cm)
  • Weight: 61.7 lbs (28 kg)
  • Power requirements: 115 V~60 Hz-65 W
  • Current: 0.8 A
  • Ambient operating temperature: 54-109° F (12-43° C)
  •  Cooler temperature range: 41-65° F (5-18° C)
  •  Power cord length: 5.4 ft. (1.65 m)

TROUBLESHOOTING

Fault indication
If a fault is detected, the display shows one of the following codes:

  • E1: Temperature sensor fault
  • E4: Defrost sensor fault

If either of these error codes appears on the display, please contact your local dealer or service center. Do not try to repair the cooler yourself.

TROUBLESHOOTINGTROUBLESHOOTING
Fault indication• Fault indication
If a fault is detected, the display shows one of the following codes:• If a fault is detected, the display shows one of the following codes:
E1: Temperature sensor fault• • E1: Temperature sensor fault
E4: Defrost sensor fault• • E4: Defrost sensor fault
If either of these error codes appears on the display, please contact your local dealer or service• If either of these error codes appears on the display, please contact your local dealer or service
center. Do not try to repair the cooler yourself.• center. Do not try to repair the cooler yourself.

 

WARNING
Electric Shock Hazard

Failure to follow these instructions can result in electric shock, fire, or death.

  • WARNING–Keep ventilation openings on the appliance clear of obstructions.
  • WARNING–Do not touch the compressor with wet hands. This could result in frost bite.
  • WARNING–Do not use mechanical devices or other means to accelerate the defrosting process, unless they are recommended by the manufacturer.
  • WARNING–Do not damage the refrigerant tubing when handling, moving, or using the cooler

ONE-YEAR LIMITED WARRANTY

Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer support, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) www.insigniaproducts.com INSIGNIA is a trademark of Best Buy and its affiliated companies.Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2020 Best Buy. All rights reserved.

DOWNLOAD LINK

Insignia NS-WC29SS9 Wine Cooler Setup Guide

https://www.insigniaproducts.com/pdp/NS-WC29SS9/6191207

Leave a Reply