iRobot RVD-Y1 Roomba Robot Vacuum User Manual

iRobot RVD-Y1 Roomba Robot Vacuum User Manual

Safety Information

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.

GENERAL

• Your robot is not a toy. Small children and pets should be supervised when your robot is operating.
• Do not sit or stand on your robot or Home Base.
• Do not use unauthorized chargers. The use of an unauthorized charger could cause the battery to generate heat, smoke, catch fire, or explode.
• Your robot comes with a region-approved power supply cord and is designed to be plugged into a standard household AC power socket only. Do not use any other power supply cord. For replacement cords, please contact Customer Care to ensure proper selection of country-specific power supply cords.
• Do not open your robot or Home Base. There are no user-serviceable parts inside. Refer servicing to qualified service personnel.
• Risk of electric shock, use indoors in dry locations only.
• Do not handle your robot or Home Base with wet hands.
• Store and operate your robot in room-temperature environments only.
• If the room to be cleaned contains a balcony, a physical barrier should be used to prevent access to the balcony and ensure safe operation.
• Clean cliff sensors to remove buildup.

CAUTION

• Do not operate the robot in areas with exposed electrical sockets in the floor.
• If the device passes over a power cord and drags it, there is a chance an object could be pulled off a table or shelf. Before using this device, pick up objects like clothing, loose papers, pull cords for blinds or curtains, power cords, and any fragile objects.
• Be aware that the robot moves on its own. Take care when walking in the area that the robot is operating in to avoid stepping on it.
• Do not use this device to pick up sharp objects, glass, or anything that is burning or smoking.

NOTICE

• This robot is intended for dry floor use only. Do not use this device to pick up spills. Do not allow your robot or Home Base to become wet.
• Do not place anything on top of your robot.
• The failure to maintain the cleanliness of charger contacts could result in a loss of ability for the robot to charge the battery.

BATTERY

• Do not open, crush, or heat above 176°F: 80°C, or incinerate. Follow the manufacturer’s instructions.
• Do not short-circuit the battery by allowing metal objects to contact battery terminals or immerse in liquid. Do not subject batteries to mechanical shock.
• Periodically inspect the battery pack for any sign of damage or leakage. Do not charge damaged or leaking battery packs, do not allow the liquid to come in contact with skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice. Place the battery in a sealed plastic bag and recycle or dispose of it safely according to local environmental regulations, or return it to your local authorized iRobot Service Center for disposal.
• Lithium-ion batteries and products that contain lithium-ion batteries are subject to stringent transportation regulations. If you need to ship this product (with the battery included) for service, travel, or any other reason, you MUST see the Troubleshooting section of your manual or contact customer care for shipping instructions.
• The battery pack must be removed from the robot before recycling or disposal.
• For best results, only use the iRobot Lithium Ion Battery that comes with the robot.
• Do not use non-rechargeable batteries. Use only the rechargeable battery supplied with the product. For replacement, purchase an identical iRobot battery or contact iRobot Customer Care for alternative battery options.
• Always charge and remove the battery from your robot and accessories before long-term storage.

About your Roomba® Robot Vacuum

Top View 

Home Base Charging Station 

Bottom View 

Buttons & Indicators 

Using Your Roomba® Robot Vacuum

Positioning the Home Base Charging Station

WARNING:
To prevent the risk of your robot falling down stairs when it is leaving or returning to the Home Base, ensure that the Home Base is placed at least 4 feet (1.2 meters) away from stairs.

Download the iRobot HOME App and connect to Wi-Fi®

• Follow step-by-step instructions to set up your Roomba.
• Set an automatic cleaning schedule and customize your cleaning preferences.
• Access to tips, tricks, and answers to commonly asked questions.

Charging

• Place the robot on the Home Base to activate the battery.
• If your robot needs to recharge mid-clean, it will return to its Home Base. Once it is sufficiently charged, it will then resume the cleaning job where it left off.
• The robot uses a small amount of power whenever it is on the Home Base. You can put the robot in a further reduced power state when not in use. For instructions and more details on this Reduced Power Standby Mode, refer to the iRobot HOME App.
• For long-term storage, turn off the robot by removing it from the Home Base and holding it downfor 10 seconds. Store the robot in a cool, dry place.

Cleaning

• Your robot will automatically explore and clean your home. It will return to the Home Base at the end of a cleaning job and whenever it needs to recharge.
• To send the robot back to its Home Base, tap. A blue light ring pattern will indicate that the robot is seeking the Home Base.
• When your robot detects an especially dirty area, it will go into Dirt Detect™ mode, moving over the area multiple times until it senses that the area has been sufficiently cleaned. The light ring indicator will flash blue.
• Tapto spot-clean a designated area. The robot will spiral outward about 3 feet (1 meter) and then spiral inward to end where it started. The light ring indicator will show a blue spiral.

Troubleshooting

• Your robot will tell you something is wrong by playing an audio alert and turning the light ring indicator red. Press CLEAN for details. Further support and instructional videos are available in the iRobot HOME App.
  
• If you are unsure if the robot is finished or paused, consult the iRobot HOME App to check on its status.

Battery Safety & Shipping
For best results, only use the iRobot Lithium Ion Battery that comes with your robot.

WARNING:
Lithium-ion batteries and products that contain lithium-ion batteries are subject to stringent transportation regulations. If you need to ship this product for service, travel, or any other reason, you MUST follow the below shipping instructions.

• Battery MUST be turned off before shipping.
• Turn off the battery by removing the robot from the Home Base and holding it down for 10 seconds. All indicators will turn off.
• Package the robot securely for shipping.
• If you need further assistance, contact our Customer Care team or visit Global. irobot.com.

Accessories

Dual Mode Virtual Wall® Barrier*

Use the Dual Mode Virtual Wall® barrier to keep the robot in the places you want to be cleaned — and out of the ones you don’t. It creates an invisible barrier that only the robot can see. You can leave the device in position between cleanings.

*Dual Mode Virtual Wall included for selected models only.

Choose the mode to meet your needs: Virtual Wall Mode:
When the switch is in the Virtual Wall position ( ), the device will create a linear barrier to block openings up to 10 feet (3 meters).

Note: This barrier gets wider as it gets further from the device (refer to illustration).

Halo Mode:
Toggle the switch to the Halo position ( ), to create a circular barrier. This will prevent the robot from approaching zones you want to protect such as a pet bowl, vase, or under a desk. The Halo barrier extends approximately 12 inches (30 centimeters) from the center of the device.

Note: The batteries will last about 8–10 months under normal use. If you are not planning to use your Virtual Wall barrier for an extended period of time, be sure to turn the switch to the Off, or middle position.

Care and Maintenance

To keep your robot running at peak performance, perform the procedures on the following pages. There are additional instructional videos in the iRobot HOME App. If you notice the robot picking up less debris from your floor, empty the bin, clean the brushes, and clean or replace the filter if needed.

Note:
iRobot manufactures various replacement parts and assemblies. If you think you need a replacement part, please contact iRobot Customer Care for more information. * Replacement frequency may vary. Parts should be replaced if visible wear appears

Emptying the Bin 

Cleaning the Filter 

Cleaning the Full Bin Sensors

1. Remove and empty the bin.
   
2. Wipe the inner sensors with a clean, dry cloth.
   
3. Wipe the bin door with a clean, dry cloth.

Washing the Bin

Important: Do not wash the filter. Remove the filter before washing the bin.

1. Release the bin, remove the filter, and open the bin door.
2. Rinse the bin using warm water.
   Note: Bin is not dishwasher safe.
3. Make sure the bin is completely dry. Reinsert the filter and place the bin back in the robot.

Cleaning the Edge-Sweeping Brus

1. Use a small screwdriver to loosen the screw holding the Edge-Sweeping Brush in place.
2. Pull to remove the Edge-Sweeping Brush. Remove any hair or debris, then reinstall the brush.

Cleaning the Front Caster Wheel

1. Pull firmly on the front wheel module to remove it from the robot.
2. Pull firmly on the wheel to remove it from its housing (see illustration below).
3. Remove any debris from inside the wheel cavity.
4. Reinstall all parts when finished. Make sure the wheel clicks back into place.

Important: A front wheel clogged with hair and debris could result in damage to your floor. If the wheel is not spinning freely after you have cleaned it, please contact Customer Care.

Cleaning the Multi-Surface Brushes

1. Pinch the brush frame release tab, lift the tab, and remove any obstructions.
2. Remove the brushes from the robot. Remove the brush caps from the ends of the brushes. Remove any hair or debris that has collected beneath the caps. Reinstall the brush caps.
3. Remove any hair or debris from the square and hexagonal pegs on the opposite side of the brushes.
4. Remove the bin from the robot and clear any debris from the vacuum path.
5. Reinstall the brushes in the robot. Match the shape of the brush pegs with the shape of the brush icons in the cleaning head module.

Cleaning the Sensors and Charging Contacts

1. Wipe sensors and charging contacts with a clean dry cloth. You can alternately use a pad of melamine foam to remove built-up debris on the robot and Home Base charging contacts.

iRobot Customer Care

USA & Canada
If you have questions or comments about your Roomba® robot vacuum, please contact iRobot before contacting a retailer. You can start by visiting global.irobot.com for support tips, frequently asked questions, and information about accessories. This information can also be found in the iRobot HOME App. If you need further assistance, call our Customer Care team at (877) 855-8593.

iRobot USA Customer Care Hours

• Monday to Friday, 9 AM – 9 PM Eastern Time
• Saturday and Sunday 9 AM – 6 PM Eastern Time

Outside USA & Canada
Visit global.irobot.com to:

• Learn more about iRobot in your country
• Get hints and tips to improve your Roomba® robot vacuum’s performance
• Get answers to questions
• Contact your local support center.

Regulatory Information

Hereby, iRobot Corporation declares that this robot vacuum cleaner model RVD-Y1 is in compliance with the EU Radio Equipment Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.irobot.com/compliance. Hereby, iRobot Corporation declares that this robot vacuum cleaner model RVD-Y1 is in compliance with the EU Radio Equipment Directive 2014/53/EU. The full text of the UKCA Declaration of Conformity is available at the following internet address: www.irobot.com/compliance.

Chemical information report listing SVHC (substances of very high concern) per EU Regulation EU 1907/2006 can be found here: www.irobot.com/compliance. This vacuum cleaning robot, model RVD-Y1, incorporates the Sundial radio module model: AXF-Y1. This vacuum cleaning robot, model RVD-Y1 operates in the WLAN 2.4 GHz band. The 2.4 GHz band is limited to operate between 2412 MHz and 2472 MHz with a maximum EIRP output power of 19.1 dBm (81.28 mW) at 2442 MHz.

This symbol on the product indicates that the appliance must not be disposed of with unsorted common municipal waste. As the end-user, it is your responsibility to dispose of the end-of-life appliance in an environmentally sensitive manner as follows: (1) returning it to the distributor/dealer from whom you purchased the product, or (2) depositing it in a designated collection point. Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling.

Please contact your local authority for further details or your nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with your national legislation. More information may be found at the following source: http://ec.europa.eu/environment/ waste/weee/index_en.html Recycle your end-of-life iRobot product responsibly per local regulations. The following is a list of the WEEE recycling organisations contracted by iRobot at the time of product sale.

©2020 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved iRobot, Roomba, iAdapt and Virtual Wall are registered trademarks of iRobot Corporation. Home Base and Dirt Detect are trademarks of iRobot Corporation. Wi-Fi and the Wi-Fi logo are registered trademarks of Wi-Fi Alliance.

REFERENCE LINK

https://www.walmart.com/ip/iRobot-Roomba-i3-3550-RVDY1-Robot-Vacuum-with-Automatic-Dirt-Disposal-MP3452-Used/466947256