Table of contents
show
JORVET J1508 Super Protection Face Shield User Manual
INSTALLATION
- Peel the protective film from both sides of the face shield and clear strap.
- Slide the clear strap through the two slots on the shield.
- Line up the holes in the shield and clear strap, and secure them in place by pushing a rivet through the holes on
both sides of the clear strap. - Insert the blue strap through slot A of the clear strap.
- Next, loop the blue strap through slot B. Be sure the end of the blue strap is on the inside, touching the head.
- Repeat Steps 4 and 5 on the other end of the blue strap.
- If necessary, adjust the length of the blue strap by pulling either end until the face shield is comfortable and secure.
Care and Maintenance
- Face shield can be cleaned with 70% ethanol or isopropyl alcohol, or with 6% bleach/water solution, or 3%
hydrogen peroxide. - DO NOT use ammonia or products that contain ammonia (such as common Windex window cleaner) – this will
- cause the PET-G material to become brittle. The face shield will last many months with proper care.
- The face shield should be discarded if scratched or fogged (with harsh chemicals) or becomes brittle or breaks.
Specifications
The Face Shield’s full length provides complete coverage, and the wrap-around design provides over-the-top, side and front face protection.
- Material: PET-G Plastic
- Color: Transparent
Face Shield Size:
- Width: 28 cm / 11 in
- Length: 20.3 cm / 8 in
- Thickness: 0.07 cm / .03 in