Pocbuds K6 Bluetooth Headphones Wireless Earbuds User Manual
Packing List
Note:
Before the first use, please remove the insulating film.
Product Overview
Pairing
- Open the charging case. They will automatically enter the pairing mode. At this time, the single earbud flashes red light.
- In this mode, turn on the Bluetooth of the phone and select “K6”. When connected, the red light will go out.
Once the earbuds and the phone are connected, they will pair with each other automatically when you open the case and take out the earbuds.
Charging
Headphone charging Put the earphones into the charging case, the charging columns of L/R, start to move upwards from 1 bar to 4 go off. bars, indicating a normal charging. 3 seconds later, the light will go off.
Charging case charging
When plugged in to get charged, the number on the charging case will flash and the charging columns will move upwards. The light will not go out until the case is fully charged. Method 1: Use a USB-C charging cable (provided) to connect an adapter (not provided) to your charging case. Method 2: Put the charging case on a wireless charger (not provided) and the case will be charged automatically. Please keep the LED power display facing up.
* Pay attention to the numbers on the digital display. If there is no change, the charging case is not charged. Power On
Power On
Auto Power On:
When you open the charging case, the earbuds will automatically turn on and start pairing.
Manual Power On:
In the shutdown or disconnected status, press and hold the touch button of the L/R earbud for 2 seconds to power it on. * Note: If the two earphones pair with each other successfully, the single oar will lichts the rod.
Power Off
- Method 1 Put the earbuds into the charging case and close the case to turn them off.
- Method 2 In the disconnected status, press and hold the touch button of the L/R earbud for 3 seconds to power off.
* Note: Before shutting them down manually, please disconnect the Bluetooth first.
For Call
For Music
Safety Instruction
- Using earphones at high to moderate volumes for extended periods will result in permanent hearing damage. It is advised you keep volume levels moderate to low at times for your safety.
- Do not use it while driving a car, cycling, operating machinery, or performing other activities that require hearing surrounding sounds.
- Do not use earphones in thunderstorm weather, the earphones may not work properly in the condition, and increase the risk of being hit by lightning.
- Earphones may not work properly under high temperature or high humidity conditions. Do not use any corrosive cleaner/oil to clean the earphones.
- If the earphone comes in contact with liquids, quickly wipe away.
- If submersed in water, do not turn the earphones on until completely dried.
FAQ
- Q: Why these earbuds can not pair with my mobile phones?
A: 1. Please make sure the earbuds are fully charged and powered on. 2. Please make sure the bluetooth of your phone is turned on. 3. Put the earbuds into the case again and close the case after confirming the 2 points above. Hold on for 1 minute. Open the charging case and reconnect the earbuds with your phone. - Q: Why does the music cut in or cut out?
A: Firstly, please keep the distance between the earbuds and your phone less than 33 feet without obstacles. Check the 2 tips below 1. Please make sure there is no obstacle between the earbuds and your device. 2. Please make sure there is no microwave oven/WiFi transmission around you. They would be more likely to produce electromagnetic interference that results in signal interruption.