Gibson-L0503183-30-Electric-Cooker-Feature

Gibson L0503183 30″ Electric Cooker User Manual

Gibson-Logo

Gibson L0503183 30″ Electric Cooker User Manual

Gibson-L0503183-30-Electric-Cooker-IMG

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Clearances and Dimensions

  • Provide adequate clearances between the range and adjacent combustible surfaces.
  • Location-Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor.
  • Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level..

Gibson-L0503183-30-Electric-Cooker-Fig1

*30* MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE BOTTOM OF AN UNPROTECTED WOOD OR METAL CABINET; OR 24* MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT LESS THAN 1/4* FLAME RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015″ STAINLESS STEEL, 0.024″ ALUMINUM OR 0.020* COPPER. 0* CLEARANCE IS THE MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED ABOVE TO PREVENT PROPERTY DAMAGE, POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS. TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE LOCATED ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5ª BEYOND THE BOTTOM OF THE CABINETS.

IMPORTANT SAFETY INSTRUCTIONS

WARNING If the information in this manual is not followed exactly, a fire or electrical shock may result causing property damage, personal injury or death.

WARNING

  • ALL RANGES CAN TIP
  • INJURY TO PERSONS COULD RESULT
  • INSTALL ANTI-TIP DEVICE PACKED WITH RANGE
  • SEE INSTALLATION INSTRUCTIONS

Important Notes to the Installer

  • Read all instructions contained in these installation instructions before installing range.
  • Remove all packing material from the oven compartments before connecting the gas and electrical supply to the range.
  • Observe all governing codes and ordinances.
  • Be sure to leave these instructions with the consumer.

Important Note to the Consumer

  • Keep these instructions with your owner’s guide for future reference.
  • As when using any appliance generating heat, there are certain safety precautions you should follow. These are listed in the Use & Care Manual, read it carefully.
  • Be sure your range is installed and grounded properly by a qualified installer or service technician.
  • Make sure the wall coverings around the range can withstand the heat generated by the range.
  • To eliminate the need to reach over the surface elements, cabinet storage space above the elements should be avoided.

Before Starting

Tools You May Need

For leveling legs and Anti-Tip Bracket:

  • Adjustable wrench or channel lock pliers
  • 516 diver or latchen Screwdriver
  • Electric Drill & 1/8″ Diameter Drill Bit (Masonry Drill Bit if installing in concrete)

Gibson-L0503183-30-Electric-Cooker-Fig4

Gibson-L0503183-30-Electric-Cooker-Fig2

Gibson-L0503183-30-Electric-Cooker-Fig3

For electrical supply connection:

  • 1/4″ & 3/8″ Socket driver or Nutdriver
    Additional Materials You May Need
  • Copper Electrical Wiring & Metal Conduit (for hard wiring)

Normal Installation Steps

Anti-Tip Bracket Installation Instructions

Important Safety Warning

  • To reduce the risk of tipping of the range, the range should be secured to the floor by properly installed anti-tip bracket and screws packed with the range.
  • Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself.
  • If range is ever moved to a different location, the anti-tip brackets must also be moved and installed with the range.
  • Instructions are provided for installation in wood or cement fastened to either the floor or wall. When installed to the wall, make sure that screws completely penetrate dry wall and are secured in wood or metal. When fastening to the floor or wall, be sure that screws do not penetrate electrical wiring or plumbing.
  • Locate the Bracket Using the Template – (Bracketmay be located on either the left or right side of the range. Use the information below to locate the bracket if template is not available). Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1-1/4* from wall when installed, you may use the wall or floor mount method. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. Place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1-1/4* from the wall when installed, attach bracket to the floor. For floor mount, locate the bracket by placing back edge of the template where the rear of the range will be located. Mark the location of the screw holes, shown in template.

Gibson-L0503183-30-Electric-Cooker-Fig5

  • Drill Pilot Holes and Fasten Bracket – Drill a 1/8″ pilot hole where screws are to be located. If bracket is to be mounted to the wall, drill pilot hole at an approximate 20° downward angle. If bracket is to be mounted to masonry or ceramic floors, drill a 5/32″ pilot hole 1 3/4″ deep. The screws provided may be used in wood or concrete material. Use a 5/16* nut-driver or flat head screwdriver to secure the bracket in place.

Gibson-L0503183-30-Electric-Cooker-Fig6

  • Level and Position Range – Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8″ is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide range back into position. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage drawer. For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range and carefully attempt to tilt it forward.

Gibson-L0503183-30-Electric-Cooker-Fig7

Electrical Connection Requirements

  • Plug the range power cable (4 conductors) into a 4 conductor range outlet. Outlet must be properly grounded and in accordance with the Canadian Electrical Code (CSA Standard (C22.1 Part 1 — latest edition) — and any local electrical code requirements.
  • Locate outlet 6″ above the floor in the wall behind the range.
  • This appliance may be connected by means of permanent “Hard Wiring.”

Model and Serial Number Location

  • The serial plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area.
  • When ordering parts for or making inquires about your range. always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range.
  • Your serial plate also tells you the Kilowatt rating (power requirements) and Voltage ratings

Care, Cleaning and Maintenance

  • Refer to the Use & Care Manual for cleaning instructions.
  • If removing the range is necessary for cleaning or maintenance, disconnect the electrical power supply. If the electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall. Pull only as far as necessary to disconnect the electrical supply.
  • Finish removing the unit for servicing and cleaning.
  • Reinstall in reverse order making sure to level the range and check electrical connections. See pages 2 and 3 for proper anchoring instructions.

Before You Call for Service

  • Read the “Before You Call” and operating instruction sections in your Use & Care Manual. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.
  • Refer to the warranty in your Use & Care Manual for our toll- free service number and address. Please call or write if you have inquiries about your range product and/or need to order parts.

Gibson-L0503183-30-Electric-Cooker-Fig8

REFRENCE LINK

https://www.gibson.com/en-US/

Leave a Reply