NetumScan L5 2D Barcode Scanner User Manual
Quick Setup Guide
This is a 1D and 2D plug-and-play model if you use a US keyboard. If you use another type of keyboard, plug the USB cable into your device, and setup the keyboard language before you use it. After that, the scanner can start to work.
Barcode Programming
Netum barcode scanners are factory-programmed for common terminal and communications settings. If you need to change these settings, programming is accomplished by scanning the bar codes in this guide. An asterisk (*) next to an option indicates the default setting.
Communication Mode
USB -KBW
When you connect the scanner to the Host via a USB connection, you can enable the USB-KBW feature by scanning the barcode below. It works on a Plug and Play basis and no driver is required.
USB COM
If you connect the scanner to the Host via a USB connection, the USB COM Port Emulation feature allows the Host to receive data in the way a serial port does.
Keyboard Language
To let the scanner accurately upload the codes, you have to set the keyboard language. For example, If you use a French Keyboard, scan below the barcode of the “French keyboard” then the scanner will upload barcodes according to the French keyboard layout. American Keyboard is set by default, if you use a US keyboard you can skip this step
Scanning Mode
Key Holding
Press the button to trigger the reading, and release the button to end the reading. Reading success or reading time over a single reading time will end the reading
Continuous Mode
Under continuous mode scanner performs continuous work. Reading success or reading time over a single reading time will end the reading. More than the specific time will automatically trigger the next reading
Auto Sense Mode
Under auto sense mode, the scanner detects the brightness of the surroundings. Trigger reading when the brightness changes. Reading success or reading time over a single reading time will end the reading. Regardless of the last success or failure to read, re-enter the detection of the surrounding environment brightness.
Terminator confiiguration
The scanner provides a shortcut for setting the terminating character suffix to CR or CRLF and enabling it by scanning the appropriate barcode below.
Beeper Volume
To select a decode beep volume, scan the appropriate bar code.
Mute
To enable or disable close all prompts, scan the appropriate bar code below.
Default Configuration
If you want to cancel all the configuration that you have done to the scanner. Scan the below barcodes to the restored factory
Symbologies
Add-On Code
An EAN/UPC barcode can be augmented with a two-digit or fiive-digit add-on code to form a new one. In the examples below, the part surrounded by the blue dotted line is an EAN-8 barcode while the part circled by the red dotted line is an add-on code.
Interleaved 2 of 5
Enable/Disable Interleaved 2 of 5
To enable or disable Interleaved 2 of 5, scan the appropriate bar code below
Note: Interleaved 2 of 5 with the length of 14 digits by default, if you have another length please scan “Any length”
Codabar
Enable/Disable Codabar
To enable or disable Codabar, scan the appropriate bar code below.
Reverse QR Code
Data Matrix(DM)
Enable/Disable Data Matrix(DM)
To enable or disable Data Matrix(DM), scan the appropriate bar code below.
Reverse Code
Maxi Code
Enable/Disable Maxi Code
To enable or disable Maxi Code, scan the appropriate bar code below.
Aztec Code
Enable/Disable Aztec Code
To enable or disable Maxi Code, scan the appropriate bar code below.
Note:
If you want other programs which are not available in this manual, please do not hesitate to contact us: service@netum.net Support For any inquiries concerning our products, please send an email to service@netum.net, and we will respond to you as soon as possible.
