Sonoff LBS L1 Lite Wi-Fi Smart LED RGB Light Strip Quick Guide
Clean the surface
Tear the backing tape
Adhere it to the surface
Power on
Cutable every 100mm
Pull out the insulation sheet, then long press “On” button for 5s until the light strip “flashes”, which means it enters the quick pairing mode.
The device will exit the quick pairing mode if not paired within 3mins. If you want to enter this mode again, long press the “on” button on the remote controller for 5s until the light strip “flashes” and release
Tap “+” and select “Quick Pairing”, then operate following the prompt on the app
User Manual
https://sonoff.tech/usermanuals
Scan the OR code or visit the website to learn about the detailed user manual and help. Scan the QR code to read the voice control instruction for Amazon Echo and Google Home.
FCC Warning
Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Hereby, Shenzhen Sonoff Technologies Co., Ltd. declares that the radio equipment type L1-2M/L1-5M/L1 Lite-5M-US/ L1 Lite-5M-EU is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://sonoff.tech/usermanuals
DOWNLOAD PDF LINK
