Table of contents
show
Locky USA TB-950 Magnum Heavy Duty Hinge Gate Closer User Manual
Features
- Fits gates 40 – 48” wide & up to 72” high
- Suitable for gate weight up to 240lb
- No hold open (suitable for security gates)
- Hydraulically adjustable closing speed
- Hydraulically adjustable latching speed
- Restrictor to avoid over opening
- Speed adjustments hidden from view
- For all temperatures down to -40°F
Product Overview
- Closer unit
- Closer housing
- Bearing
- Washer
- Drive plate
- Top pivot
- Bottom support
- Internal bracket
Instructions
- Step 1
Remove all parts from housing #2
- Step 2
Weld housing #2 to underside of gate allowing correct gap between gate frame and gate post (measurement between centre pivot of closer and gate post is 4 3/8”) - Step 3
Weld the closer housing #2 to the underside of the gate in the correct position giving the desired clearance between the gate and post. The distance from the face of the post to the centre of the closer pivot is 4 5 /16” (110mm) when gate is in closed position. - Step 4
Weld bottom support #7 to the gate post - Step 5
Weld top pivot #6 to top of gate post
- Step 6
After galvanizing/painting, grease roller bearing, and replace parts into closer housing #2 placing the drive plate #5 to the correct handing and then place a small piece of adhesive tape across drive plate #5 and closer housing #2 to secure while mounting gate.
- Step 7
Mount gate to post - Step 8
Adjust closing speed (hole nearest post) and latching speed (hole farthest from post) using 3mm Allen key
Maintenance
The regularity of maintenance should reflect the frequency of use, environment and the likelihood of vandalism or misuse. Should you require more information about gate closer maintenance, please contact us using the contact information at the bottom of this page. The following checks and lubrication should be regularly completed:
- Check to ensure all fastenings are secure
- Check function of closer
- Lubricate roller bearing
REFRENCE LINK
https://lockeyusa.com/product/tb950/
