8bitdo-M30-2.4G-Wireless-Controller-User-Manual-featured-img

8bitdo M30 2.4G Wireless Controller User Manual

Views: 147
Table of contents show

8bitdo logo

8bitdo M30 2.4G Wireless Controller User Manual

8bitdo-M30-2.4G-Wireless-Controller-User-Manual-prduct-img

M30 2.4G mini

8bitdo-M30-2.4G-Wireless-Controller-User-Manual-fig-1

  • Press the Start button to turn on the controller
  • Hold the Start button for 3 seconds to turn off the controller
  • Hold the Start button for & seconds to force the controller off

MD mini / MD mini 2 / Genesis mini

Wireless Connection

  1. Connect the 2.4G receiver to the USB port of your MD mini / MD mini 2 / Genesis mini console
  2. Presetter reon art the ust the torture is recognized doy setim top console

Switch

  • Switch system version needs to be 3.0.0 or above
  • Please ensure the [Pro Controller Wired Communication] is enabled in the system setting

Wireless Connection

  1. Connect the 2.4G receiver to the USB port of your Switch
  2. Press the Start button and wait until the controller is recognized by the system to play

Wired Connection

  1. Connect the controller to the Switch via a USB cable and wait until the controller is recognized by the system to play.

Windows

  • Windows 10 (1903) or above is required for your Windows device.

Turbo Function

  • The D-pad, Start, Mode, and Home buttons are not supported
  • Hold the button you would like to set turbo functionality to, then press the Star button to activate/deactivate its turbo functionality.

Battery

  • Status –
  • low battery
  • battery charging
  • battery full charged
  • LED indicator –
  • Red LED blinks
  • Red LED stays solid
  • Red LED turns off

35 hours of playtime with a 480 mAh built-in lithium battery pack, fully recharged between 1 to 2 hours The controller will automatically shut down if there is no connection within 1 minute after startup or no activity within 15 minutes after connection The controller will not shut down when it’s over a wired connection

Repair the controller with the receiver
If the controller loses the connection with the receiver or needs to pair with another same model 2.4G receiver, please follow the instructions below:

  • Press the Start button to turn on the controller, hold the mode button for 3 seconds to enter the pairing mode, and the status indicator starts to blink rapidly
  • Connect the 2.4G receiver to your device
  • Both status indicators become solid when the connection is successful

Support

  • Please visit support.8bitdo.com for further information & additional support

REFERENCE LINK

https://www.8bitdo.com/m30-2-4g/

Tags: , , , , ,

Leave a Reply