SoundPeats Mini HS Wireless Bluetooth Earbuds User Manual
Pairing
Open the charging case lid and remove both earbuds from the case, then tear off the insulating film, and place them back into the case.
- The earbuds automatically pair with each other after being removed from the case. LED indicator light on main earbuds flashes in red and white light alternately, the second earbud stays in solid white light.
- Activate Bluetooth on the device, and choose “SOUNDPEATS Mini HS” from the Bluetooth list to pair.
Multi-Point Connection
SOUNDPEATS Mini HS supports connecting with two devices simultaneously.
- Turn off the Bluetooth on Device A after successfully connecting
- Repeat the pairing steps to pair the earbuds to Device B.
- Open the Bluetooth on Device A and reconnect.
Reset
- Clear the pairing record from your device.
- Place back both earbuds into charging case and make sure they are in charging status.
- Press and hold both buttons for 10s until both LEDs flash in red and white twice, reset complete.
Wearing
- Idendify left and right earbud, and put them on.
- Rotate both earbuds and find the most comfortable position to wear.
Product Diagram
Touch Control
Q&A
Q1: What does the LED on the charging case indicate?
Q2: How to charge the case?
- Use a Type-C adapter to charge the case (current not over lA).
- Please charge the earbuds and case at least once every 3 months when not in use for a long time.
Q3: Why are the earbuds still connected to my phone after returning the earbuds to the case and closing the lid?
- The charging case is out of battery. The case will not turn the earbuds off if the case battery is dead.
- Please make sure the earbuds sit well in the charging case, and that the charging contacts on both the earbuds and charging case are clean. Please try something like a microfiber cloth to clean the contacts.
Q4: How to disconnect the headphones from the phone?
Method 1. Put the earbuds back into the charging case, the earbuds will turn off and disconnect automatically
Method 2. Turn off the Bluetooth of the phone
Method 3. Remove both earbuds from the case, press the touch keys of both earbuds for 6 seconds, and the earbuds will disconnect from the current phone and enter into pairing state.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful Interference in a residential installation, This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular Installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for hello.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation,
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
DOWNLOAD PDF LINK
