LUXPRO Outdoor Wireless Temperature Transmitter User Guide
INSTALLATION INSTRUCTIONS
- Install the included 2 AA batteries by removing the 4 screws located at the back of the transmitter. The LED on the transmitter will flash every 6 seconds. Do not close the battery compartment yet.
- Remove the top cover of the thermostat and plug the receiver into the white connector located to the bottom left under the touch screen. (A)
- Place the antenna wire into the 4th vent as shown (B). Clip the receiver into the 1st vent (C).
- Press the “RESET” button (D) on the receiver module for 10 seconds to activate the transmitter and receiver. The outdoor temperature will appear on your thermostat within 5 minutes. Make sure that the dot to the left of the outdoor temperature (E) flashes approximately every 15 seconds. If after 5 minutes the outdoor temperature is not displayed on the thermostat or if the dot to the left of the outdoor temperature (E) is not
flashing, unplug the receiver module from the thermostat, remove batteries from the transmitter and start the installation procedure again. - After placing the transmitter in a permanent location, ensure that the dot to the left of the temperature (E) flashes approximately every 15 seconds. If the dot to the left of the temperature (E) is not flashing, change the transmitter location.
- Use the chart below as a reference for the recommended humidity settings.
HARDWARE:
LUX Products Corporation warrants the original end user (“Customer”) that new LUXPRO® branded products will be free from defects in workmanship and materials, under normal use, for three (3) years from the original purchase date.
SOFTWARE:
LUX Products Corporation warrants to Customer that the LUXPRO® thermostat software will perform in substantial conformance to its program specifications a period of three (3) years from the date of the original purchase.
EXCLUSIONS:
This warranty excludes physical damage to the surface of the product, including cracks or scratches on the touch-screen or outside casing damage caused by misuse, neglect, improper installation, unauthorized attempts to open, repair, or modify the product, or any other cause beyond the range of intended use; damage caused by accident, fire, power changes, other hazard, or Acts of God use of the product with any device if such device causes the problem.
EXCLUSIVE REMEDIES:
Products Corporation, Customer’s sole and exclusive remedy will be, at LUX Products Corporation’s sole option and expense, to repair or replace the product. Replacement products or parts may be new or reconditioned or a comparable version of the defective item. LUX Products Corporation warrants any replaced product or part for a period of ninety (90) days from shipment, or through the end the original warranty, whichever is longer.
DISCLAIMER
NEITHER LUX PRODUCTS CORPORATION NOR ITS SUPPLIERS SHALL BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE OR USE OF THIS PRODUCT, WHETHER BASED IN CONTRACT, TORT OR POSSIBILITY OF SUCH DAMAGES. LUX PRODUCTS CORPORATION’S ENTIRE LIABILITY SHALL BE LIMITED TO REPLACEMENT OR REPAIR OF THE PRODUCT.
FCC STATEMENT
- THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
- THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. THIS DEVICE HAS BEEN DESIGNED TO OPERATE WITH THE INCLUDED ANTENNA, AND HAVING A MAXIMUM GAIN . THE REQUIRED ANTENNA IMPEDANCE IS 52 OHMS.
